Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Tank Journal

Reply
 
Thread Tools Display Modes
  #1  
Old 10-02-2015, 05:03 PM
Seth81's Avatar
Seth81 Seth81 is offline
Member
 
Join Date: Dec 2011
Location: Calgary
Posts: 189
Seth81 is on a distinguished road
Default

Yeah the bathroom and shower could be shrunk down. So I think this could work, but I will have to go to site to make sure I'm okay for the shower drain.

If my drawing is accurate, I should be able to accommodate a 96"x30"x30" with about 24" behind the tank and about 3.5" on the the sides (the 8'4" measurement is between the posts)

Any thoughts about this layout if it works? I still am not sure about allowing for front access to top and bottom and what if any material to make any cabinetry out of. All I know is I want to use some material that is already in use in the house so the tank looks like it is suppose to be there.

Reply With Quote
  #2  
Old 10-02-2015, 06:07 PM
sphelps's Avatar
sphelps sphelps is offline
Member
 
Join Date: May 2006
Location: Lyalta, East of Calgary
Posts: 4,777
sphelps is on a distinguished road
Default

That layout looks pretty good and if you stick to only 30" wide back access only won't be terrible if it's too challenging to make front access work with your finishing plans. You'll have lots of time to figure out those details relating to access and finishing but some cabinetry type finishing that matches what was used elsewhere (kitchen, bathroom, wet bar, etc) is one option. Few examples:





Reply With Quote
  #3  
Old 10-04-2015, 02:38 PM
Myka's Avatar
Myka Myka is offline
Moderator
 
Join Date: Mar 2004
Location: Saskatoon, SK.
Posts: 11,268
Myka will become famous soon enough
Default

Your new layout looks really good Seth! I like the photos Steve posted up too. Not rock work you were wanting, but I think the above photos are more modern looking anyway.
__________________
~ Mindy

SPS fanatic.

Reply With Quote
  #4  
Old 10-05-2015, 04:07 AM
Seth1981 Seth1981 is offline
Junior Member
 
Join Date: Sep 2015
Location: Calgary
Posts: 3
Seth1981 is on a distinguished road
Default

Yeah I think my wife prefers to use the same material we've used for our kitchen cabinets, just gotta source it, or find someone who can. But that's a far off problem.

I went to the new house today to measure where all the rough ins are, and found that the builder for some unknown reason put the drain directly under the fish tank and not in the spot as per the plan drawings.




Ugh, so I am sure this will be a bit of a fight with the builder!

I guess I should have seen it in this pic, also see why I can't move the shower very much?



I had planned on using the area under the tank for a large sump with a huge refugium, so having that drain there will be very problematic. I guess I will see if the builder is able to move it. UGH

Last edited by Seth1981; 10-05-2015 at 04:13 AM. Reason: Added pictures
Reply With Quote
  #5  
Old 10-16-2015, 03:56 PM
Seth81's Avatar
Seth81 Seth81 is offline
Member
 
Join Date: Dec 2011
Location: Calgary
Posts: 189
Seth81 is on a distinguished road
Default

So I am still wrestling with the builder about that floor drain and what can be done. So I will have to wait a bit to finalize the fish room layout and tank dimensions.

I've been doing a lot of thinking about what I want to do differently this time around, and what lessons I learned from my current setup, what worked well and what didn't. So I thought I would take a second to write them down.

1. Automatic water changes probably saved my fish from my work schedule.
2. ATO only works well when you do not relay on level switches!
3. Install a drip tray under the sump and all external plumbing!
4. I feel that I wasted a lot of money on chemicals for coral growth
5. External pumps will leak, it's only a matter of time (reeflo hammerhead)
6. DIY LED fixtures was fun to build but not worth it in the end
7. No more tanks over 30" tall
8. Add fish and coral slowly to system
9. Sump design worked well: Always ensure there is enough surge capacity in the event the return pump fails and the overflow plus 1 or 2" from the tank fully drains into sump.
10. Had two outbreaks of Ich, not sure if the UV sterilizer helped slow the spread, but only lost 2 fish to Ich over 3 years.
11. Low iron (Starphire glass) scratches easily.
12. Need more flow! The turn over rate I had was 10x the tank volume an hour, but more/better power heads would have helped in my previous tank.
13. Went through a ton of GFO/Carbon, and had to change media more frequently then I would have liked. Planning on building an Algae turf scrubber and use two BRS jumbo carbon reactors.
Reply With Quote
  #6  
Old 10-17-2015, 02:38 AM
gregzz4's Avatar
gregzz4 gregzz4 is offline
On Hiatus
 
Join Date: Oct 2011
Location: Burnaby, B.C.
Posts: 4,890
gregzz4 will become famous soon enough
Default

Have you thought about moving the fish tank wall out a few feet ?
This will give you the space you need to have full access from behind.

I also like Steve's idea of having the tank flush on the viewing side with some full-access panels.
And the portal is a must for anyone with an in-wall build !!! Great idea Steve
Reply With Quote
  #7  
Old 10-19-2015, 06:47 PM
Seth81's Avatar
Seth81 Seth81 is offline
Member
 
Join Date: Dec 2011
Location: Calgary
Posts: 189
Seth81 is on a distinguished road
Default

That wall can't move because of the stair case. As is, the wall is pretty close to that bottom step. I could jog the wall at the end of the bedroom, but I think that may look a little odd.

Quote:
Originally Posted by gregzz4 View Post
Have you thought about moving the fish tank wall out a few feet ?
This will give you the space you need to have full access from behind.

I also like Steve's idea of having the tank flush on the viewing side with some full-access panels.
And the portal is a must for anyone with an in-wall build !!! Great idea Steve
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 08:30 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.