Cloudy Water Ideas

[kien]

Originally Posted by ruslicus

So today I've got my Hanna PO3 checker and I am getting 0.03ppm which aligned to Denny's result. I used another Ca test Red Sea and I am getting 410ppm. Mine was showing 450ppm Should I start dosing a little bit Ca or keep testing couple of more days to confirm Ca is dropping? Alk dropped to 8.4, PH range 7.9-8.2.

And once again, all your numbers look just fine :-) P03 is reasonably low should continue to drop (although probably at a slower rate) from this point onward. Ca at 410 is great. What is your target? When I was dialing my Ca in I waited an entire water change cycle to see what the total drop was between water changes, and then calculated how much I needed to dose to compensate for the Ca drop in between water changes.