Beananimal Overflow - Ball or Gate Valve?

[Aquattro]

Originally Posted by Tyler Werbowski

In Victoria Blue World, Safari, Andrew Sheret. Van Isle Water closes early on Saturday so I was out of luck.

Order from J&L I guess. Any ideas?

Tyler, there are a couple people in Van today going to J&L, they might be able to grab one for you.

[Werbo]

Thanks for all the responses. Probably gonna order one. I'll have to be sump-less for a couple days. Luckily I have a small bio-load.

Thanks again.

[Werbo]

I posted a "hail mary" in the buying forms. If no one has a gate valve in Victoria it looks like I'll have to order one.

Just want to make sure that this will do the trick? I think I want the slip to slip rather than threaded.
Please advise.

http://www.conceptaquatics.ca/index....-ii-sch80.html

Thanks in advance...

[ScubaSteve]

Originally Posted by Tyler Werbowski

I posted a "hail mary" in the buying forms. If no one has a gate valve in Victoria it looks like I'll have to order one.

Just want to make sure that this will do the trick? I think I want the slip to slip rather than threaded.
Please advise.

http://www.conceptaquatics.ca/index....-ii-sch80.html

Thanks in advance...

I actually put slip-slip unions on either side of my gate valve. That bastard is expensive, so it's getting recycled through many future builds.

[scubadawg]

Originally Posted by Tyler Werbowski

I posted a "hail mary" in the buying forms. If no one has a gate valve in Victoria it looks like I'll have to order one.

Just want to make sure that this will do the trick? I think I want the slip to slip rather than threaded.
Please advise.

http://www.conceptaquatics.ca/index....-ii-sch80.html

Thanks in advance...

I wpuld go threaded, I just setup my Bean animal, and took photos, will be posting on my 187 gallon tank build later today