Beananimal Overflow - Ball or Gate Valve?

[don.ald]

Originally Posted by Tyler Werbowski

Seems I can't find a gate valve locally.

If I am patient will I be able to find the sweet spot with a ball valve or will it just not happen?

Where have you looked?

[ScubaSteve]

With a ball valve, small changes make a big different. Over time as junk builds up in the valve, snails get in there, etc, everything will go to crap and you get to do everything over again. Ball valves aren't just more sensitive to adjustments, they tend to be "sticky". So, when you want to go and make that fraction of a turn adjustment to dial it in, it's next to impossible to do so. It''l stick, you'll overshoot it and you're right back to where you started.

Seriously, do it once and do it right. You'll put in a ball valve and regret it as soon as the tank is up and running to the point where having to change the valve is a nightmare, if not impossible.

[Werbo]

In Victoria Blue World, Safari, Andrew Sheret. Van Isle Water closes early on Saturday so I was out of luck.

Order from J&L I guess. Any ideas?

[don.ald]

I was thinking van isl water, or I would think Wes tech irrigation on Alfha st. Would be your best bets.
But a Monday wait.
J&l would ship Monday get it tues.

[syncro]

Can you use a smaller diameter drain line to get a cheaper gate vavlue? Full siphon drains a surprising amount of water compared to a partial siphon.

I suspect you can by with a ball value it will just mean a lot more fiddling because of the overshoot scubasteve mentions. I find I need to make tiny adjustments - a few degrees turn on a gate value that requires multiple full turns to fully open or close.

[The Guy]

I plan on using a gate valve to dial in the proper flow and a same diameter ball valve in the same line for any shutting off of the drain line, then I never have to worry about resetting my flow.

[Aquattro]

Originally Posted by Tyler Werbowski

In Victoria Blue World, Safari, Andrew Sheret. Van Isle Water closes early on Saturday so I was out of luck.

Order from J&L I guess. Any ideas?

Tyler, there are a couple people in Van today going to J&L, they might be able to grab one for you.

[Werbo]

Thanks for all the responses. Probably gonna order one. I'll have to be sump-less for a couple days. Luckily I have a small bio-load.

Thanks again.

[Werbo]

I posted a "hail mary" in the buying forms. If no one has a gate valve in Victoria it looks like I'll have to order one.

Just want to make sure that this will do the trick? I think I want the slip to slip rather than threaded.
Please advise.

http://www.conceptaquatics.ca/index....-ii-sch80.html

Thanks in advance...

[duncangweller]

That will do the job. When you plumb it in just make sure you use a 'union' on at least one side of it so you can remove the valve and re-use it if you move/upgrade etc etc.

Dunc

Sent from my HTC Incredible S using Tapatalk 2