Help programming RKE myReef float switch

[gregzz4]

And FYI you all, reefme sent me a bunch of PMs to help too ...
Mighty nice of him

[gregzz4]

So, to clarify for the next poor sap reading this ....
When programming in myReef, you need to change the FUNCTION of the unit plugged into the PC4.
In my case, it is a pump and I had originally set it to Pump
I changed it to Switch, and then I was able to set the On when / Off when
Hope this helps someone else

[gregzz4]

This is definately going to take more work tomorrow

I obviously can't set my heaters as a switch
I'll need to set up an alarm for them

[reefme]

What is the heater got to do with switch? Isn't the Temp probe take care of that?

[gregzz4]

If I change, say, channel 4 on PC4 #2, from Heater to Switch, I lose the temp control ....
What am I missing ?

[gregzz4]

I want the first switch we just programmed to turn off not only that pump, but also the heaters and the skimmer all at once.
Then I want to set a re-start delay for the skimmer of, say, 30 seconds

[gregzz4]

BTW, I read every post on the DA site, and this is still not making total sense