Hustlers 300G Panzer Project (Up and Running)

[intarsiabox]

Originally Posted by Hustler

Well I got the plumbing mostly done.... went to leak test the return pump side and lo and behold a pinhole leak on 2 fittings...... So Im tearing it all out tomorrow and buing all new stuff as Im stressed to poop epoxies or 2 part puttys will leak down the road for a fix.... it was either to rough a sandpaper or the glue set to soon as the 2" to 1 1/2" reducers have to go in at the same time and hope for the best situation.... Just mad now


Hope tomorrow is a better day

It looks like you have some PVC to ABS fittings together, did you use a transition glue? Wrong glues could cause a leak or weak joint. I've never had to sand any plastic pipe fittings before, usually the fit is almost water tight as is and the wet glue helps slide the pieces all the way together.

[Hustler]

Hey....sorry for the late replies.... the stainless welds have been calling 14 hrs a day.....
and ontop of that..... lol in my tired rum n coke state i tried to attach my skimmer to a direct overflor pipe..... 24hrs and nothing..... cant be working right so i will have to add power pumps submersed and start from scratch there.....
No abs to PVC in this run i did it all first pics abs and top notch as best i could....problem was I was roughing with sandpaper and it worked against me..... straight cuts and double glue from here on out.......ive done a thousand joints and never had a problem.....seems its just when it counts it gives the headaches....
Any advice or imput is more than appreciated
Got the return side all up and running but the skimmer side.....tooo much pump to keep the water in the 100 gph sump.... tried running full on one solid overflow with air injector....no go..... so back to the drawing bored....