Euro Reef Nano Skimmer

[trilinearmipmap]

I have gone through two meshwheels since I got my nano skimmer in July 2009.

Around a couple of months ago I ordered 2 new meshwheels but it would be 2 weeks or so to get them delivered from the U.S. so I decided to do a foam mod to hold me over temporarily.

I got some black open-cell foam, the holes are maybe 2-3 mm size. I glued it on to the impeller where the meshwheel should go, then I trimmed it to a round disc the right size.

The foamwheel has been performing great for over two months and my two replacement impellers are sitting in a box.

I have also done a gate valve mod and the skimming is much more consistent since then.

[Oscar]

Originally Posted by trilinearmipmap

I got some black open-cell foam, the holes are maybe 2-3 mm size. I glued it on to the impeller where the meshwheel should go, then I trimmed it to a round disc the right size.

The foamwheel has been performing great for over two months and my two replacement impellers are sitting in a box.

I have also done a gate valve mod and the skimming is much more consistent since then.

do you have any photos of your mods that you can post. Your description of the foam sounds a bit like the foam that comes with the Little Fishes reactor???

[Oscar]

Originally Posted by trilinearmipmap

I have gone through two meshwheels since I got my nano skimmer in July 2009.

Around a couple of months ago I ordered 2 new meshwheels but it would be 2 weeks or so to get them delivered from the U.S. so I decided to do a foam mod to hold me over temporarily.

I got some black open-cell foam, the holes are maybe 2-3 mm size. I glued it on to the impeller where the meshwheel should go, then I trimmed it to a round disc the right size.

The foamwheel has been performing great for over two months and my two replacement impellers are sitting in a box.

I have also done a gate valve mod and the skimming is much more consistent since then.

In December of 2010 the above was posted as a solution to buying the expensive diamond grid impellers. Unfortunately I have never seen a photo of the mods. has anyone else had success with this mod? Or have you found a different supplier of the diamond mesh?