anyone piped their tank with Aryclic tubing or Clear PVC?

[brizzo]

Originally Posted by Milad

I don't have a setup yet. I'm designing it before my tank gets here
I did create a model for it
http://www.canreef.com/vbulletin/sho...6&postcount=23

I see now, you're going with a peninsula tank!

Do you know if the bottom of your tank is tempered glass? If not, you could drill towards a corner and have a return pipe 'standing', with a 90 at the water surface, then some lock line. the 90 would need a small hole drilled in it for a syphon break.

Depending on the vision of your tank, this may or may not work.

If it was me, I would have the return where the overflow box is. Using your sump return to create flow in your tank at both ends isn't the most effective. If you're going to have a canopy, put a propeller pump of some kind on the far end

[Milad]

I was thinking of putting a Tunze 6205 by the herbie
And I believe the bottom is tempered

Another idea maybe is running the pipe inside the tank as it comes over by the herbie and paint it black. Then have a bunch of little opening shooting down to the end of the tank. So with a bunch of openings maybe I dont need a big width on the pipe so its less noticeable?

Or even better yet
Could I return under the overflow box and have a tunze 6205 suck in most of the return and push it down the length of the aquarium?

Would that create enough flow? Or would i need two 6205s or two 6105s

Originally Posted by nazerine

I see now, you're going with a peninsula tank!

Do you know if the bottom of your tank is tempered glass? If not, you could drill towards a corner and have a return pipe 'standing', with a 90 at the water surface, then some lock line. the 90 would need a small hole drilled in it for a syphon break.

Depending on the vision of your tank, this may or may not work.

If it was me, I would have the return where the overflow box is. Using your sump return to create flow in your tank at both ends isn't the most effective. If you're going to have a canopy, put a propeller pump of some kind on the far end

[Milad]

Here is example of my other idea
I think I actually like this one. But im sure someone will find a flaw. I could have it higher up the overflow box too.

[untamed]

Originally Posted by Milad

Here is example of my other idea
I think I actually like this one. But im sure someone will find a flaw. I could have it higher up the overflow box too.

This idea has an serious reverse siphon potential. You would be 100% dependent on somehow breaking the reverse siphon with a check valve or some other method....otherwise you would drain your tank into the sump during a power failure.

[Milad]

Could I just not have a couple holes in the pipe at the top of the tank to break the siphon? or is it because it goes so far down that the holes wont work.

[superduperwesman]

What will stop water from spraying out the holes when the pump is on or am I miss understanding something?

[Milad]

when the pump is on, the holes are jsut under the water, when the pump is off the holes will be above the water

[golf nut]

clear will be opaque in 24 minutes.