![]() |
|
View Poll Results: How Long Do You Mix A Fresh Batch Of Salt Before Putting it in the Tank? | |||
A Couple of Hours |
![]() ![]() ![]() ![]() |
47 | 28.66% |
12 Hours |
![]() ![]() ![]() ![]() |
8 | 4.88% |
24 Hours |
![]() ![]() ![]() ![]() |
59 | 35.98% |
2 Days |
![]() ![]() ![]() ![]() |
35 | 21.34% |
However Long it Takes the Heater to Get it to Temperature |
![]() ![]() ![]() ![]() |
15 | 9.15% |
Voters: 164. You may not vote on this poll |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||||
|
|||||
![]() Like a week or two. I fill up the mixing barrel, and then let the pump do its thing. Usually though I forget about it until the next weekend, which is why it gets to age for a week.
|
#2
|
|||||
|
|||||
![]() One week. I do weekly water changes so when I finish with one I get the water for the next one ready. I also find it very helpful to have the new saltwater on hand in case of an emergency or when I sell a bunch of frags to someone (so that I can replace the water the frags were bagged in).
__________________
"We shall dive down through black abysses... and in that lair of the Deep Ones we shall dwell amidst wonder and glory forever." - H.P. Lovecraft Old 120gal Tank Journal New 225gal Tank Journal May 2010 TOTM The 10th Annual Prince George Reef Tank Tour |
#3
|
|||||
|
|||||
![]() In an emergency I've mixed and used it inside of five min's. Most of the time it's more then a week. I have two 35 gallonish rubbermaid cans, one for RO and one for Saltwater. I have a 900gph pump running continuously on the salt side to keep it mixed. I've never heated the water.
__________________
Robb |
#4
|
||||
|
||||
![]() I mix my salt until it is all dissolved, < 5 min, using tank temperature water and pump it in as I siphon detritus and old water out. Been doing that for years. Change 10% water every week. Fish and corals are in excellent condition.
|
#5
|
|||||
|
|||||
![]() about 10 - 15 min, as soon as I can see clear to the bottom of the bucket, it goes in the tank
|
#6
|
|||||
|
|||||
![]() Anywhere from when it's clear (after adjusting for salinity) to a couple days ahead... If too much water evaporates from my mixing bucket (I try to avoid this anyhow, distilled water isn't cheap) there is a white deposit left on the pump and bucket since I dose the freshly mixed water with calcium and magnesium while it's mixing. The pump heats the water to a reasonable temperature also, so I don't use a heater.
__________________
Calvin --- Planning a 29 gallon mixed reef... |
#7
|
||||
|
||||
![]() i just pour my salt into my fish tank.
|
#8
|
|||||
|
|||||
![]() A little warning: Twice I mixed up Seachem Reef salt and let it sit circulating in a 20gal garbage can with a small powerhead for about a month between water changes. The first time I did a water change everything looked a little ****ed off, the second time the tank crashed; 2 coral colonies, 2 fish and a brittle star died. The tank was a 4 year old 135gal. There was nothing directly wrong with the salt, when I used it again after letting it mix for less than a week everything was fine. But for some reason it seems seachem can not be allowed to sit and mix before use for a month.
__________________
"We shall dive down through black abysses... and in that lair of the Deep Ones we shall dwell amidst wonder and glory forever." - H.P. Lovecraft Old 120gal Tank Journal New 225gal Tank Journal May 2010 TOTM The 10th Annual Prince George Reef Tank Tour |
#9
|
||||
|
||||
![]() I keep two 12 liter jugs of salt water pre-mixed. One jug let's me do both of my nano's. I usually don't let them sit for more than 1 to 2 weeks.
|
#10
|
|||||
|
|||||
![]() Quote:
|