T5 lighting for SPS?

[rzadun]

I am using a current USA fixture that has twelve HO tubes 3feet each over my 240 gallon tank. It is 30 inches deep and I do not think the light at the bottom is sufficient for SPS. At the top is very brite.

[Trigger Man]

I'm using the tek t5 unit with 4 bulb 4 foot unit in my 5 foot 24 inch deep tank and all my sps is growing. I do put my most light intense sps 15 inches or closer to the top (highest sps is 8 inches from the light), but I've got stags, birdsnest, and monties near the bottom with no issues (I did recently add a 2 bulb 36 inch glo unit to the back of the tank, but that was for some supplimentry lighting as the tek unit sits closer to the front of the tank then in the usual middle)

[rstar]

I believe Stones is using a sfiligoi t5 unit on his 90 and it is an sps dominated tank, beautiful corals, i believe he has a picture thread going on here somewhere.

[randallino]

Thanks rstar
For the heads up about Stones he does have a nice setup.


Rbacchiega
"Are you looking at using it over your 90?"

Yes the problem I'm having is that I have a Euro braced tank (Black in colour) so an 8 bulb fixture maybe somewhat of a waste because of the opening on the top is only 12" wide.
Would a 6 bulb 54 watt provide enough light for sps from the top 1/2 of the tank?

[Rbacchiega]

I don't imagine it would be a problem.

[Stones]

Thanks for the compliments Ryan. Here is a pic of my tank from a few weeks back. Forgive my photography skills as I can't seem to get the white balance set correctly for the life of me.



I'm using the Sfiligoi Stealth 8 x 54 watt fixture and the only corals which I keep are SPS. I thought that after switching from 2 x 250 Watt metal halide that I would have to shuffle some corals around to move them higher in the tank but that has not been the case. I can keep acros on the sandbed with no ill effects. My corals are also starting to colour up much faster than when I was using metal halides. I recently moved this reef in September of 2008 and after which almost all of my acros browned out on me. I was using the halide setup until December of this year with near zero improvement in colouration. As soon as I switched to the T5 fixture, I noticed colours were coming back in less than a weeks time. The colours still aren't anywhere near what they were before I moved but at least im making some progress now with the new fixture.

I don't have the links handy but I've read through a thread on RC where 8 x 54 watt T5's (in a TEK fixture) were compared to 2 x 250 metal halides and the T5s actually came out on top for par readings, even though they used less watts. T5's also produced more even par readings throughout the tank whereas the par readings with the metal halide varied considerably due to shadowing of the point source.

I would definately recommend T5's to anyone thinking about making the switch or just getting into keeping SPS. With that said, I would not recommend T5's for all setups. Tanks over 30" deep or cube type tanks would be situations where using metal halide setups would work much better than T5's.

[jus68]

Stones,

Would you please tell us the T5 bulbs combination you have for your setup and what make?

Thanks,

[Stones]

Originally Posted by jus68

Stones,

Would you please tell us the T5 bulbs combination you have for your setup and what make?

Thanks,

I'm currently using: 4 Aquascience Blue (22K) bulbs, 1 KZ Fiji Purple, 2 KZ New Gen Coral Light (14K), and 1 Aquascience Special (15K, but looks like a 10K). In reality, my tank actually looks quite a bit bluer than the picture as the white balance on my camera is impossible to get set correctly.

Next bulb change I'd like to try all ATI bulbs since progressive reef now carries them as the pro colour is more subtle than the fiji purple. I'm not a huge fan of the Aquascience Special (15K) either and next time I'd swap it out for another KZ New gen or an Aquascience Duo (17.5K) if I choose not to go all ATI.

Regarding the par tests done on RC, I can't find the thread but I seem to remember the T5 unit being a TEK while the metal halide was a 2 x 250 retro with lumenarc type reflectors. Neither of the setups were being overdriven and the PAR readings were very close which only proves that T5s can produce the same or similar light intensity to metal halide.

If you were to compare apples to apples and make the comparison more fair, you would have to pair up an ATI powermodule or Sfiligoi Stealth against a high end metal halide fixture like Sfiligoi or Giesmann. That being said, both setups used in the test were choosen because they were readily available for purchase and represented the most commonly employed fixtures used for either metal halide or T5s. I'm sure higher PAR levels could have been achieved had they used higher end fixtures but even then PAR readings would likely have been similar as adding active cooling to T5's makes a huge difference while using a better reflector/bulb combo for metal halides also makes a huge difference.

[Whatigot]

haha...
long story short, you're good either way.

[Whatigot]

Originally Posted by Stones

Thanks for the compliments Ryan. Here is a pic of my tank from a few weeks back. Forgive my photography skills as I can't seem to get the white balance set correctly for the life of me.



I'm using the Sfiligoi Stealth 8 x 54 watt fixture and the only corals which I keep are SPS. I thought that after switching from 2 x 250 Watt metal halide that I would have to shuffle some corals around to move them higher in the tank but that has not been the case. I can keep acros on the sandbed with no ill effects. My corals are also starting to colour up much faster than when I was using metal halides. I recently moved this reef in September of 2008 and after which almost all of my acros browned out on me. I was using the halide setup until December of this year with near zero improvement in colouration. As soon as I switched to the T5 fixture, I noticed colours were coming back in less than a weeks time. The colours still aren't anywhere near what they were before I moved but at least im making some progress now with the new fixture.

I don't have the links handy but I've read through a thread on RC where 8 x 54 watt T5's (in a TEK fixture) were compared to 2 x 250 metal halides and the T5s actually came out on top for par readings, even though they used less watts. T5's also produced more even par readings throughout the tank whereas the par readings with the metal halide varied considerably due to shadowing of the point source.

I would definately recommend T5's to anyone thinking about making the switch or just getting into keeping SPS. With that said, I would not recommend T5's for all setups. Tanks over 30" deep or cube type tanks would be situations where using metal halide setups would work much better than T5's.

Isn't that pretty much a top top of the line t5 fixture?(sfiligoi)
also, what t5 fixture, bulbs, reflectors and ballasts vs what halide fixture, bulbs, reflectors and ballasts were used in this comparison?