Question regarding Sequence Dart Pump

[untamed]

Originally Posted by 'Ol Nobodaddy

Okay...thats what i did well minus the cannual service. What did you do for your annual service...just clean everything out?

Yes...just dismantle the pump as completely as I could and clean it out. Aside from being a bit grungy, there were quite a few small snail shells stuck in the impeller vanes.

But as I mentioned, I could not get the impeller off in order to access the seals...even though I knew one of them needs replacing.

[mark]

The impeller on mine was way more than hand tight. Just used water pump pliers (protected the impeller with a couple of wraps of electrical tape from the pliers teeth) and a screw driver on the end of the motor shaft.