I think I need help with my RO/DI

[Delphinus]

[digital-audiophile]

LOL, yeah, I was always told that fish people were a different bunch

Thanks for the offer Tony, I really appreciate it. If Drew and I have any problems Ill be sure to phone

[danny zubot]

I was actually thinking about putting it in my furnace room as my main tank is plumbed through the wall into ther, where I have my sump and my 60 gallon. I would imagine it could be tapped into the cold water feed line to the bathroom sink from there.

Thats what I did and it works really well. There should be a drain close to your hot water tank (provided you HWT is close to where you want the install done) that you can use for your waste water dump.

[digital-audiophile]

The floor drain is about 4 feet away from where I think I could mount the unit so I hope that should work.

[mark]

Got mine in the furnace/sump room as well works great for the last 2 years.

Using 1/4" line and JG fittings, from the output of the ro/di unit I have a tee. One side goes to a mini ball valve then a line long enough to reach where I store my mix barrel and for other uses. The other side of the tee goes to another mini valve then a float valve for ATO in my sump.

Have a 1/2" line tee'd into the drain for the furnace (Hi-efficiency furnace with line to floor drain) which I just put the 1/4" waste water line from the ro/di into. By having the ro/di waste line loose, I can just pull it out of the 1/2" line for a quick check or ever want to measure waste ratio.

Use the piercing valve to source water for the ro/di unit from the copper line that supplies the HWT.

[Matt]

I used to fill 5 gal totes and carry them downstairs. I recently got smart, went to HD and bought a dehumidifier float valve, a bit of 1/4" tubing, a T, and a small ball valve. Now, the line goes downstairs, and filling is easy!

Originally Posted by mark

Got mine in the furnace/sump room as well works great for the last 2 years.

Using 1/4" line and JG fittings, from the output of the ro/di unit I have a tee. One side goes to a mini ball valve then a line long enough to reach where I store my mix barrel and for other uses. The other side of the tee goes to another mini valve then a float valve for ATO in my sump.

Have a 1/2" line tee'd into the drain for the furnace (Hi-efficiency furnace with line to floor drain) which I just put the 1/4" waste water line from the ro/di into. By having the ro/di waste line loose, I can just pull it out of the 1/2" line for a quick check or ever want to measure waste ratio.

Use the piercing valve to source water for the ro/di unit from the copper line that supplies the HWT.