Profilux II plus aquarium controller

[Matthias Gross]

If ProfiLuxControl finds the card but isn't able to communicate with ProfiLux these are possible reasons:
- port 10001 is blocked (in windows or in the router) - for searching the card another port is used!
- an other port than 10001 is selected in WLAN card or ProfiLuxControl
- the baudrate in ProfiLux (only adjustable over the frontpanel of ProfiLux) is different to the baudrate in the WLAN card (only adjustable over the lantronix web configuration site) (recommendation: 9600 on both sides)
- the WLAN is not plugged in completely
- worst case: card and/or ProfiLux is defective - but this never happened until now

[mediaone]

Thank you for the reply.

1) My router security is off including all port blocking.
2) The port information is interesting. How can I change the port that the WLAN card is using. I never set it to use port 10001. I never saw that in the tutorial guide or anything like that (or I read over it). Where can I change it?
3) I double checked that the WLAN is plugged in securely.

Regards,

[Slick Fork]

Hi there,

I've got a Tunze 6055 hooked up to my profilux and was wondering who else had Tunze's connected? I am curious as to "safe" settings on the current page. I'm worried about things like too short duration or if the "right angled wave" setting will damage the pump.

Thanks