Profilux II plus aquarium controller

[jdjeff58]

In the Profilux software version 3.02, under the 'controlling' drop down, the 'temperature', 'measurement data', and 'sensor overview' temperatures all read in celcius. The temperature graphical display reads in celcius as well. I see no place to change the units that display within the program itself. I have farenheit selected, but it only applies to the profilux display.

Is there a way to get the temperature values within the program to read in °F? Thanks.

[Marsh]

Hello,

I know this is a long standing issue but after reading the pdf and uploading new 3.02 software, I am still unable to connect wirelessly.
The pdf is very obtuse and circuitous. Do I have to create an Ip address on the unit itself and then try to connect? Anyway, I would like to get an idiot proof step by step, preferrable with screen prints, for Windows (XP and ? Vista), Profilux 3.02 software, and the Profilux (Plus) II unit. These are not inexpensive units and the instructions leave much to be desired. Adding a wireless printer or computer to my network is a no-brainer.

[monitors-direct]

Have you got the new step by step guide with screen shots I have been emailing out?

[zapco98]

Originally Posted by monitors-direct

Have you got the new step by step guide with screen shots I have been emailing out?

Could I get you to send those to me? I've pm'd ya my email address...

Thanks

[Matthias Gross]

Hi to all,

a lot of questions the last days.

- display
the display mode (temperature, salinity, whatever) effects only to the display of the ProfiLux. I will add this feature in one of the next releases of ProfiLuxControl
- wireless
since 3.02 (firmware ProfiLux and ProfiLuxControl) it is much easier to do the settings. But: Some basic wireless settings which depend on the used wireless router or access point still must be done in any case. The new ProfiLuxControl 3.03 (coming soon) has some more functions to support this.
I hope Michael's instructions helped?

[monitors-direct]

I have now sent the instructions to every one who has requested them either by direct email, pm or on the forum, if you have not received them please check your spam folder and then let me know and I will send again.

In the UK we will have a wireless system up and running in about 1 weeks so can help further with any set up issues. the ony issue we have found so far is what type of router you are using but we are working on this also.

We are offering FREE global support to all users at support@ghl-profilux.com this is support only we do not market or sell in the USA or Canada, please contact Proline for this service.

hope it all made sense

Regards
Michael

[Marsh]

I am now at work and will check my home email tonight. Nevertheless, are there instructions regarding use of a access point (AP) (wireless router)? The default setup is for Ad Hoc apparently. In addition are you aware of any problems with setting the system up on Vista?

[jdjeff58]

Originally Posted by jdjeff58

In the Profilux software version 3.02, under the 'controlling' drop down, the 'temperature', 'measurement data', and 'sensor overview' temperatures all read in celcius. The temperature graphical display reads in celcius as well. I see no place to change the units that display within the program itself. I have farenheit selected, but it only applies to the profilux display.

Is there a way to get the temperature values within the program to read in °F? Thanks.

The same holds true for conductivity. If you change from mS to Salinity, the units stay at mS in the program.

[Marsh]

I just joined and have not been on any mailing list.

my email mwmarsh@cox.net