Profilux II plus aquarium controller

[mshur]

I am trying to program my controller without my new tank . i use to have AQ and this is something new for me, i hope i will not sound silly
i got a seconf PH module to control my CA RX. In my old AQ I use to have settings :
If PH<6.4 then CO2 ON
If PH>6,5 then CO2 OFF
How can I program something like this in Profilux?

thankx,Mike

[Aqua-Digital]

Hiya

You will find this in the pH control screen of the profilux pc software, i am assuming you are accessing the ProfiLux from your pc?

You then set the corresponding modes in this screen

For example you would set the maintained reading to 6.5 with a hysterix of 0.1 and set to switch on when the reading goes high.

I will try and find some screen shots for you, but please can you confirm you are viewing the settings via a pc, this will help in giving you advise.

Regards
Michael
www.aqua-digital.com

[mshur]

Hi MIchael.
thankx for your respond. I do control it from my PC via rs cable. I am trying to use LAN module but i canot conected .
Wireless comp----router-----profilux....this conection dosnot work.



mike

[Aqua-Digital]

What firmware version are you running? You should be running V3.03 - Do you have an rs232 port on the back of your pc?

Regards
Michael
ww.aqua-digital.com

[mshur]

yes, i am
I did upgrade last nite..I went thrue LAn-tutorial step by step. No problem with RS cable connection,but LAn is the problem..

[Aqua-Digital]

If you send a pm to matthias he will have you up and running in no time with LAN, this is one area I am still learning myself but will be fully clued up in the next week.

In the meantime drop matthias a pm and i am sure all will connect. You will find his posts here if you scroll back

Regards
Michael
www.aqua-digital.com

[mshur]

Thankx Michael
i will do so......
i am going to work on it a litlle more...This is still very new for me)


mike