|
|
|
|
|
#1
06-19-2007, 08:51 PM
|
||||
|
||||
Matthias is just back from a contest he lost, see here http://news.bbc.co.uk/1/hi/england/cornwall/6689999.stm
 
|
|
#2
06-20-2007, 01:26 AM
|
||||
|
||||
|
Thought I stopped that picture of my brother in cornwall being published, darn Uk media!
Hey guys made it from the UK to canada in one piece!! Not been on here much in the past week while getting the family settled in ottawa. Good news is that i have a sponsorship with Canreef pending so watch this space. I will announce the company name shortly, and its main line will be ...... G H L !! Great to be local!
|
|
#3
06-20-2007, 04:18 PM
|
||||
|
||||
|
Quote:
|
|
#5
06-21-2007, 02:53 PM
|
||||
|
||||
|
Hiya
ASAP I understand matthias is still working on them. We have WLAN up and running in the UK on a test bed using the new software with no issues, looks like the release is going to be a real breeze! Regards Michael
|
|
#6
06-23-2007, 09:51 AM
|
||||
|
||||
|
EVG-AP2 version 4.xx
Matthias Gross
i have read the spec sheet for this and would like to know if it was possible to connect two ballasts to one relay control set leaving one side unsed. i am aiming to utilize one port to control two ballasts from the profilux , and then add a led bar on the second port,using a splitter YL2. Himat
|
|
#7
06-30-2007, 09:30 AM
|
||||
|
||||
|
You can connect several ballasts to one EVG-AP output. The only limitation is the inrush current of all connected ballasts (in sum). It must not exceed 100A, with good ballasts you should not have a problem with up to 5 ballasts on one relay. The inrush current of a ballast is usually given in the datasheet.
But why do you want to use a splitter and only one relay? Do you use L3L4 for other devices? If not there is no need for this configuration. And: The new (W)LAN-tutorial - german version - is finally ready. Today we translate it, in the evening we will publish the english version. I'll post later again when it can be downloaded.
|
Hybrid Mode
