|
|
|
|
|
#1
01-14-2007, 02:15 AM
|
|||||
|
|||||
niloc16 the pumps have to be assigned to L2 and one to L3.I bought mine at H.R. so they should be the same
|
|
#2
01-14-2007, 06:29 AM
|
|||||
|
|||||
|
thanks man, i havent had the problem since so whatever i messed with worked. i'll have to go over what i changed and see where the setting are.
|
|
#3
01-14-2007, 10:10 AM
|
|||||
|
|||||
|
i have had the problem with the lighting not shuttting off three times now on 3 different sockets, 3 different lights. 2 times with the halides each one is plugged into different sockets and on seperate powerbars and 1 time with my actinics (2 54w T5's) also on a different socket. the only way that i can get them to turn off is to reassign the outlet to be permanent and change it back to a clock timer. tapping on the powerbar did not switch it off.
|
|
#4
01-14-2007, 11:08 AM
|
||||
|
||||
|
One problem solved and just getting the next one...
The most important question is: Is the LED on when the socket has power? If yes: The hardware (powerbar) is OK and is just doing what it is told to do by ProfiLux. ->then there may be a mistake in your settings. In this case please give me the complete settings of your timer (mode, count of times, the times, ...). If no: The powerbar does not what ProfiLux wants.
|
|
#5
01-14-2007, 06:55 PM
|
|||||
|
|||||
|
ah man, my power bar just stayed on permanantly too for my actinics.I havent even ajusted anything in aweek.the LED still works with the settings like yours too.I think its pooched.I think?
|
|
#6
01-15-2007, 04:46 AM
|
||||
|
||||
|
@honkey sauce: What are Actinics? Metal halide lamps? (i am still learning English).
Do i understand you correctly: LEDs follow the settings you made but the socket's power is not switched simultanesly to the LED?
|
|
#7
01-15-2007, 09:25 AM
|
|||||
|
|||||
|
ok matthias have more info on the power bar problem. are you getting sick of hearing from me yet. anyway, tonight i had the problem again with lighting staying on but this time all 3 metal halides stayed on. the leds for these sockets were out. the only way i can get it to reset is change the outlet to 'permanent' and when i save this change i can here the relay click and the led comes on. now this proves that the relay was open otherwise i would not hear it close when i changed the outlet to permanent. so why then did the lighting stay on? only after i again change the outlet from 'permanent' back to the appropriate clock timer did the lighting go out because the settings were to have the lighting off.
actinics are just blue lighting fluorescent bulbs. mine are t5 lamps i'm not sure what honkey sauce are but actinics is just the blue bulbs used to simulate dawn and dusk
|
|
#8
01-16-2007, 02:59 AM
|
|||||
|
|||||
|
Quote:
|
Hybrid Mode
