Quote:
Originally Posted by mark
Going from the photo, think about this.
Have the top of the sump and ref and about the same height. Inter connect with a large bulkhead as low as you can on the ref (no valve). Assuming the pump is on the far right of the sump with no baffles to the right, the water level in the ref will be the same as the pump compartment. Use a auto topoff to maintain.
Have no baffles in the ref other than a strainer on the bulkhead and maybe some eggcrating in front of the strainer. Negative is if the strainer gets blocked ref overflows so place a second interconnect at the top.
With the interconnect below no bubbles like Untamed said.
Not sure of your planned height in your in the pump compartment but adjust the ref height to max the volume in the ref tub.
|
Yeah this is similar to what Untamed has suggested. I just got off the phone with him actually. I am going to have a gate valve though in the line between the fuge and sump to create a bit of a herbie effect. He was explaining to me how it doesnt matter if they are at the same height, having a gate valve will still allow me to keep the water height in the fuge higher than in the sump if I wanted or the other way around. Im not sure if that makes sense how I wrote it but I think I "get it" now.
So there will be a 2" line between the fuge and sump with a gate valve to control the water level in the fuge therefore also controlling how much water flows between the two. There will also be an emergency drain at the top of the fuge, just like a regular herbie.
I will post pics as soon as I get the plumbing father along.
But thank you to all you guys who have helped so far...I couldn't have even gotten this far without all your help!
11-03-2007, 11:24 PM
Threaded Mode
