|
|
|
|
|
#1
03-25-2011, 01:53 AM
|
||||
|
||||
Do I need venting to outside for this new Tank build?
I am thinking of setting up a 150 g or so tank (72 L x 20 H x 24 W) in my basement. The sump is going to be in the furnace room right beside the tank, and the main tank will be in a large open air rec/bar room, there is a decent sized window to the right of where the tank will be. My question is will I need to punch out a hole and install a fan in either the furnace room or the other room? I ran a 120ish gallon in my last place main floor and had no venting issues, It was a very open concept, this house has spiral stairs to the basement so that part is open to the main and upper floor, and a room away from where the tank will be.
So what do you guys think?
__________________
RSM 250. Clownfish, Fox face, Blue tang, Yellow tang, Kole tang, Clown tang, Coral beauty angel, French Angel, splendid dottyback. CUC, softies, lps, sps. 
|
|
#2
03-25-2011, 02:57 AM
|
|||||
|
|||||
|
humidity control
I recommend that you do, I hooked up my fan to a honeywell dehumidification switch. This automatically turned the fan on when it reached a preset value. I have central air in the house so humidity is not an issue in the summer/early fall, but it can be a problem in the winter months. I would seriously consider this option, as it is easier to do it now, planned ahead, than later on down the road. Just my opinion, HTH,
Bob
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes.
|
|
#3
03-25-2011, 03:13 AM
|
|||||
|
|||||
|
I second the idea as well. I wouldn't have done it any other way. This way you have control over it rather than you not being able do to anything about it later. Besides, you're in the the basement so it's really easy to get a hole out there.
|
|
#4
03-25-2011, 03:17 AM
|
|||||
|
|||||
|
Dez did you buy a regular bathroom fan or one of those fancy inline ones like the fantech units? How many cfm for that room you have? I'll be putting that in place sometime this year myself...
|
|
#5
03-25-2011, 03:29 AM
|
|||||
|
|||||
|
Hey Brett,
It was just a regular bathroom fan that is hooked to a dehumidistat. I didn't really look at the cfm cause that room is so tiny (5 x 8 I think). You've been in there, 2 people barely fit in there. Completely worth it!
|
|
#6
03-25-2011, 03:56 AM
|
|||||
|
|||||
|
Quote:
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes.
|
|
#7
03-25-2011, 04:18 AM
|
|||||
|
|||||
|
You guys all run this air outside with a dedicated duct correct? I don't think tying into the home's ventilation is good considering the constant humidity and possible corrosion issues. Do you also have a dedicated fresh air feed?
|
|
#8
03-25-2011, 03:24 AM
|
||||
|
||||
|
So venting out of the furnace room with the sump and equipment is good enough? Or do I need to be venting out of the rec room where the tank is as well? The downside to this basement is it is fully developed and runs crown moldings and drywalled ceiling so I have to be careful on what I get cut. I do like the idea of running the fan to a dehumifier system, who do I get to set that up normally? The builder put the humidifer control and sensor in the furnace room, so I hope that does not cause problems for the hardwood, as the whole main is hardwood. What do you guys think?
__________________
RSM 250. Clownfish, Fox face, Blue tang, Yellow tang, Kole tang, Clown tang, Coral beauty angel, French Angel, splendid dottyback. CUC, softies, lps, sps.
|
|
#9
03-25-2011, 03:30 AM
|
|||||
|
|||||
|
Quote:
|
|
#10
03-25-2011, 03:51 AM
|
||||
|
||||
|
yes Dez it makes sense, thanks for the info.
__________________
RSM 250. Clownfish, Fox face, Blue tang, Yellow tang, Kole tang, Clown tang, Coral beauty angel, French Angel, splendid dottyback. CUC, softies, lps, sps.
|
Hybrid Mode
