Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Reef

Reply
 
Thread Tools Display Modes
  #1  
Old 01-26-2011, 07:17 AM
KushBubbles KushBubbles is offline
Junior Member
 
Join Date: Apr 2010
Location: Calgary
Posts: 4
KushBubbles is on a distinguished road
Exclamation Correct Procedure for Switching Tanks? HELP

I have a 37 gal but the glass cracked about 6 inches across the right side from the top. It is being maintained with duct tape and a towel but have a 30 long ready to go but I'm not sure how to go about it. Is it as easy a just moving everything or is there any thing to watch out for??? Any tips and info would be greatly appreciated, thanks Canreef
Reply With Quote
  #2  
Old 01-26-2011, 09:28 AM
MitchM's Avatar
MitchM MitchM is offline
Member
 
Join Date: Mar 2002
Location: Water Valley, AB
Posts: 1,280
MitchM is on a distinguished road
Default

Can you describe your setup?
Fish, coral, sand, live rock?
__________________
Mitch

Reply With Quote
  #3  
Old 01-26-2011, 09:38 AM
KushBubbles KushBubbles is offline
Junior Member
 
Join Date: Apr 2010
Location: Calgary
Posts: 4
KushBubbles is on a distinguished road
Default Setup

A small bio load (regal tang, tomato clown, chromis), a frog spawn, small colony of zoa's.
About 50 lbs of live rock and about 30in x 12in x 3in of sand, with worms and microorganisms about 1-1.5 inches deep.

?? what would you suggest i do??
Reply With Quote
  #4  
Old 01-26-2011, 09:49 AM
MitchM's Avatar
MitchM MitchM is offline
Member
 
Join Date: Mar 2002
Location: Water Valley, AB
Posts: 1,280
MitchM is on a distinguished road
Default

-First drain some existing tank water into a pail or cooler and move the fish into that. Leave the corals for now.
-Second I would suggest taking all the live rock that is NOT sitting in any sand and moving it over to the new tank then siphon the existing tank water over to the new tank. Do not move the rocks sitting in the sand or disturb the sand itself.
-Third make sure your mechanical systems are running properly in your new setup
-Fourth transfer the fish into the new tank
-Fifth transfer the corals into the new tank

After that let your new setup settle down for a few days and the fish get used to their new place while you clean up the broken tank and deal with what is left in there.

Basically set up your new tank as a bare bottom live rock system.
__________________
Mitch

Reply With Quote
  #5  
Old 01-26-2011, 09:56 AM
MitchM's Avatar
MitchM MitchM is offline
Member
 
Join Date: Mar 2002
Location: Water Valley, AB
Posts: 1,280
MitchM is on a distinguished road
Default

As for dealing with what is left behind -

If you want to reuse the sand it will need to be thoroughly rinsed before it can be put into the new tank. Never try to "move" a sandbed.
The live rock that is sitting in the sand will need to be placed in a separate container and left for a few weeks with a circulating powerhead and 10% water changes 1X/week because it probably has absorbed some H2S in the areas that were buried. You don't want that in your new tank.
Do weekly water tests to monitor it's water quality.
__________________
Mitch

Reply With Quote
  #6  
Old 01-26-2011, 01:35 PM
Binare's Avatar
Binare Binare is offline
Member
 
Join Date: Dec 2008
Location: Calgary
Posts: 262
Binare is on a distinguished road
Default

How long has your original setup been running?
__________________
Do you smell that? Just waaalk away...... sloooowly
Reply With Quote
  #7  
Old 01-29-2011, 03:58 AM
KushBubbles KushBubbles is offline
Junior Member
 
Join Date: Apr 2010
Location: Calgary
Posts: 4
KushBubbles is on a distinguished road
Default

Its been about a year that a year. good lighing for about a month

instead of rinsing the sand i have been told to mix a it with 3x the amount of new sand? would you suggest that to kick start bacterial grow in the new sand?
Reply With Quote
  #8  
Old 01-29-2011, 09:02 AM
MitchM's Avatar
MitchM MitchM is offline
Member
 
Join Date: Mar 2002
Location: Water Valley, AB
Posts: 1,280
MitchM is on a distinguished road
Default

Quote:
Originally Posted by KushBubbles View Post
Its been about a year that a year. good lighing for about a month

instead of rinsing the sand i have been told to mix a it with 3x the amount of new sand? would you suggest that to kick start bacterial grow in the new sand?
You would be transferring over all the organic matter and killing most of the soft bodied worms and critters if you just mixed it all up.
That organic matter would sit there and rot until new critters that kept the sandbed moving repopulated, which could take a few months.

If you want to seed some new sand I would set the new tank up with new sand only then use a cup or so from the old tank, skimmed off the first inch or so of the old sandbed.
I would still go ahead and rinse out the rest of the old sand before putting it in the new tank.
__________________
Mitch

Reply With Quote
  #9  
Old 01-29-2011, 04:50 PM
ALang ALang is offline
Member
 
Join Date: Aug 2009
Location: Sherwood Park, Alberta
Posts: 614
ALang is on a distinguished road
Default

Like they said, DON"T mix the old sand with the new.
When you transfer the old sand bed to a new tank, the pretty delicate organisms that were in the old bed will be mixed up. Those critters who lived in certain parts/layers of the sandbed will be disturbed/cut-up and most will probably die. Then, in your new tank, the dead organisms will pollute it and cause it to crash. You will have nothing but problems. Voice of experience.
So your live rock that you have rescued will help filter and re-seed your new tank. If you want a new sandbed, put in freshly rinsed new sand, and seed that with a cup or two of a buddy's sandbed. Believe me, it's cheaper in the long run. You won't have epic battles that'll take years to resolve.
You will have to go through a small cycle regardless of how you transferred your livestock. Just be vigilant and be ready to do lots of water changes.
Less trouble than to have everything die off due to sand bed collapsing on you, trust us.
Good luck.
Reply With Quote
  #10  
Old 01-30-2011, 07:36 PM
KushBubbles KushBubbles is offline
Junior Member
 
Join Date: Apr 2010
Location: Calgary
Posts: 4
KushBubbles is on a distinguished road
Default

Few Questions:

- Is it old sand for another project possible to re-use my sand for another project, and what procedure if so?


---Can i still use the live rock that was in the sand?

-And by seed the sand do you mean mix it in to the new sand?

Thanks for the help
Reply With Quote
Reply

Tags
correct, procedure, switching, tanks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 01:24 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.