|
|
|
|
|
#1
04-03-2009, 06:15 PM
|
|||||
|
|||||
Crazy Glue and Crazy Glue Gel
I used the Gel for the first time last night and this morning a couple of pieces I was gluing to rocks came loose overnight. Not a big deal it happens with regular CG but when I fished up the loose pieces they were soft and tacky. As soon as I removed my fingers from the water and dried them they stuck to the towel and each other.
Has anyone else noticed CG gel not curing properly? Maybe I got a bad batch? My experience with regular CG is it cures right away into a solid even under water.
__________________
|
|
#2
04-03-2009, 06:18 PM
|
|||||
|
|||||
|
Yea, I tried the gel.... Didn't like it a whole lot... had to hold the frag for awhile under water before it would cure... I tried Taylored Aquatics crazy glue, and it works alot quicker IMO.
__________________
180G Office Reef. Started Sept 2012 http://www.canreef.com/vbulletin/showthread.php?t=88894 62G Starfire Reef. Started Jan 2013 http://www.canreef.com/vbulletin/showthread.php?t=89988
|
|
#3
04-03-2009, 07:16 PM
|
|||||
|
|||||
|
When I glue frags to plugs, I make sure to clean and dry the plug, and lightly dry where I'm going to glue on the skeleton. Apply glue, let air dry for about 30 seconds, put them in a bucket of water while I mount others .. then back in the tank. Never had any come loose yet.
__________________
28g Nano Cube drilled with 13g sump in stock stand. Vertex IN80 Skimmer, Phosban 150 Reactor, Apex Controller, DIY LED with stock hood, dimmable Established March 2006
|
|
#5
04-03-2009, 07:55 PM
|
|||||
|
|||||
|
Quote:
__________________
- John - 3x20g Display Established June 08|Koralia nano, 1, 4|Euroreef Skimmer|250W MH retro kit|Mag 18 return|RODI 120g Display Established Jan 1, 09|Vortech MP40|Koralia 4|I-Tech 100 w Tunze 9410.04A|Aquactinics Constellation 7x54W|Mag 18 return|RODI
|
|
#6
04-03-2009, 07:58 PM
|
|||||
|
|||||
|
Like mentioned above I make sure frag and plugs are somewhat dry and then let the glue set for 30 seconds on the plug then add the frag and then let it set for another minute or two. I use CG gel with no problems. I believe the gel takes a bit longer to set.
hth
__________________
I bent My Wookie
|
|
#7
04-03-2009, 08:20 PM
|
|||||
|
|||||
|
Quote:
__________________
28g Nano Cube drilled with 13g sump in stock stand. Vertex IN80 Skimmer, Phosban 150 Reactor, Apex Controller, DIY LED with stock hood, dimmable Established March 2006
|
|
#8
04-03-2009, 09:23 PM
|
|||||
|
|||||
|
you are probably using too much gel. The outer layer is contacting the water and curing, creating a skin at prevents the rest from curing. You can either use less or breach the skin that forms to allow it to fully harden.
|
Hybrid Mode
