WTB new-ish Sedra 5000 (Calgary)

richtg · #1 03-22-2009, 08:39 AM

Looking for a Sedra KSP-5000 with needle wheel (for my ASM G3).

I want the old style bigger version if possible (it has the half-round on one side and a handle.

My impeller swelled and melted itself into the housing.

andestang · #2 03-22-2009, 04:41 PM

I looked for quite awhile, I think for the price you would be better off getting one off Wendal at Ocean Aquatics.

new but handy · #3 03-22-2009, 04:52 PM

The impeller swelling is apparently a common problem with the sedras. I brought a few back from the coast for people when their impellers swelled. I brought back a few for the same people because their pump didn't last a week. On the flip side I have had one in my mixing bin for 3 months with no problem.

richtg · #4 03-22-2009, 05:20 PM

Thanks guys. I figured that I might end up buying new.

I was going to take the impeller magnet to work and try to turn it down on a lathe a few thousanths of an inch to see if that gives them more longevity. I had mine running for 5 years with no problem, and then one day - gone. I had to destroy the plastic around the impeller just to get it out!

I wonder how hot it must have got...

Tom R · #5 03-22-2009, 05:49 PM

Quote:

Originally Posted by richtg

Thanks guys. I figured that I might end up buying new.

I was going to take the impeller magnet to work and try to turn it down on a lathe a few thousanths of an inch to see if that gives them more longevity. I had mine running for 5 years with no problem, and then one day - gone. I had to destroy the plastic around the impeller just to get it out!

I wonder how hot it must have got...

I had the same problem with 1 of my Sedra 9000. The impeller has what seems to be a rubber membrane over the magnet and if it develops a leak the salt water gets into the iron of the magnet and it rusts immediately. As it rusts it expands ever so slightly and then seizes within the impeller housing. I ruined the impeller trying to get it out of the housing but once out the housing seemed OK. I then bought a new impeller from OA ($50 - $60) and everything was fine.

Tom R

richtg · #6 03-22-2009, 06:40 PM

Quote:

I had the same problem with 1 of my Sedra 9000. The impeller has what seems to be a rubber membrane over the magnet and if it develops a leak the salt water gets into the iron of the magnet and it rusts immediately. As it rusts it expands ever so slightly and then seizes within the impeller housing. I ruined the impeller trying to get it out of the housing but once out the housing seemed OK. I then bought a new impeller from OA ($50 - $60) and everything was fine.

Tom R

I find it harn not to consider buying a whole new pump for the extra $40. I wonder why they charge so much for the impeller...

Does anyone know if my needlewheel will fit onto the standard impeller magnet/shaft that comes with one of these pumps?