Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Reef

Reply
 
Thread Tools Display Modes
  #1  
Old 02-29-2008, 08:12 PM
adidas's Avatar
adidas adidas is offline
Member
 
Join Date: Dec 2004
Location: calgary
Posts: 1,098
adidas is on a distinguished road
Send a message via MSN to adidas
Default calciuum reactor help

How low should the ph drop? what level should i set my ph to? and I have the bubble counter at about 80 bubbles per min, that ok?
Reply With Quote
  #2  
Old 02-29-2008, 08:19 PM
Delphinus's Avatar
Delphinus Delphinus is offline
Member
 
Join Date: Dec 2001
Location: Calgary
Posts: 12,896
Delphinus has a spectacular aura aboutDelphinus has a spectacular aura aboutDelphinus has a spectacular aura about
Send a message via MSN to Delphinus
Default

Depends on the size of the reactor, 80bpm might be normal. When I had my larger reactor I had bubble rates around 120-150bpm, but with my smaller reactor (probably about 2l of media) I have it around 30bpm. The flipside to a smaller reactor is I have to refill it more often, but I don't mind.

I run my reactor at a pH of 6.7. You can get away with a lower pH but the more you lower it, the softer the media gets. Once it turns to mush you pretty much have to throw it out because the pump has a harder time pushing water through it.

You can also get away with a higher pH but you might have a harder time maintaining levels in the tank.

I find that 6.7 is a happy medium though.
__________________
-- Tony
My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee!
Reply With Quote
  #3  
Old 02-29-2008, 08:22 PM
Delphinus's Avatar
Delphinus Delphinus is offline
Member
 
Join Date: Dec 2001
Location: Calgary
Posts: 12,896
Delphinus has a spectacular aura aboutDelphinus has a spectacular aura aboutDelphinus has a spectacular aura about
Send a message via MSN to Delphinus
Default

One caveat: I use the older style calcium reactor media (2-3mm particle size). The newer medias tend to be things like really coarse crushed media (like 1/2" - 1" in size), you can run a much lower pH with that kind of media than you can with the smaller stuff. I'm not sure but you might even *need* to run the pH lower with the coarser stuff.
__________________
-- Tony
My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee!
Reply With Quote
  #4  
Old 02-29-2008, 08:29 PM
adidas's Avatar
adidas adidas is offline
Member
 
Join Date: Dec 2004
Location: calgary
Posts: 1,098
adidas is on a distinguished road
Send a message via MSN to adidas
Default

thanks for the help Tony

Its a GEO 612 rector, holds quite a bit of media.ome question, after the solenoid closes, is it normal for the bubble counter to take a few mins to stop?
Reply With Quote
  #5  
Old 02-29-2008, 08:33 PM
Delphinus's Avatar
Delphinus Delphinus is offline
Member
 
Join Date: Dec 2001
Location: Calgary
Posts: 12,896
Delphinus has a spectacular aura aboutDelphinus has a spectacular aura aboutDelphinus has a spectacular aura about
Send a message via MSN to Delphinus
Default

Hmmm, I think it's normal for it to be non instant because what's happening is the valve is shut upstream of the needle valve, but there is still residual pressurized CO2 downstream and so however long it takes to reach equilibrium is how long it will take to stop bubbling .. a few minutes does seem sort of long though.. What's your outlet pressure set at? I run mine around 18psi, I found anything less I just couldn't really get a consistent bubble rate (I have a Milwaulkee brand regulator which is reputed to be not really one of the best, so that could be a part of it for me).
__________________
-- Tony
My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee!
Reply With Quote
  #6  
Old 02-29-2008, 08:38 PM
adidas's Avatar
adidas adidas is offline
Member
 
Join Date: Dec 2004
Location: calgary
Posts: 1,098
adidas is on a distinguished road
Send a message via MSN to adidas
Default

hmmm the guage on the right says 5, the one on the left we had at between 0.1 and 0.2. not sure which one is which

Last edited by adidas; 02-29-2008 at 09:05 PM.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 08:32 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.