Sick and Tired of Waveline pumps

[byee]

Originally Posted by FishyFishy!

I was bored today....took my jebao 12000 controller and power supply and plugged in my old DC10000 return pump and it runs like normal haha. Good thing jebao parts are available. Might just get some of those to get the wavelines up and running.

If I'm reading this right, the controller from the Jabao works fine on the Waveline?

Please confirm.

[Waveline]

Originally Posted by byee

If I'm reading this right, the controller from the Jabao works fine on the Waveline?

Please confirm.

Jebao and Waveline are completely different and absolutely not compatible.

[daplatapus]

Originally Posted by Waveline

Jebao and Waveline are completely different and absolutely not compatible.

Then on behalf of the many members on this board that have your pumps, I BEG of you to help us figure this out ... please.

Originally Posted by Waveline

Any 24V power supply would work as long as the AMP are correct.

And that would be...?

[Ryanerickson]

Almost bought one of these but this tread saved me thanks guys went with the vertex v6 bit more reliable

[Aquattro]

Originally Posted by Ryanerickson

Almost bought one of these but this tread saved me thanks guys went with the vertex v6 bit more reliable

I'd say after this thread, anyone buying one needs a good shaking

[daplatapus]

Originally Posted by Aquattro

I'd say after this thread, anyone buying one needs a good shaking

And the sad thing is, I truly think that with a bit of communication this company could have had a waaaayyyyy better outcome

[Aquattro]

Agreed Dom. This guy even pops up every 3 months, no explanation on the lack of communication. Gives half answers, then gone again. I wouldn't touch one of their products. Too many other good options for people.

[_Adrian_]

Originally Posted by daplatapus

And that would be...?

Looks like a 24V 8.8A ( 200W ) Meanwell off eBay like the one pictured on page 1 post #6

I do however suggest the 360W version as its cooled via a fan rather then rely on convection cooling, but I do not believe it would fit in the original casing and would require a custom enclosure.

[daplatapus]

But according to this:

Originally Posted by Waveline

Please do not wire the power supply to the pump directly!

Send us your serial number and we will warranty the pump.
email: daniel@rlss.ca

THE WAVELINE PUMP CANNOT BE WIRED DIRECTLY TO A POWER SUPPLY AND BY PASS THE CONTROLLER. THE DRIVER IS IN THE CONTROLLER AND YOU CANNOT BY PASS THE DRIVER. IN ADDITION THE CONTROLLING SOFTWARE IS IN THE CONTROLLER, WITHOUT THE CONTROLLING SOFTWARE NOTHING WILL WORK.

I can't use just the PSU. So the weak link IS the controller. It's been my only complaint (other than the customer service) of the system right from the start. I need to figure out how to make my own

[roblarss]

its more than likely the same as my speed wave pumps. I have them running off of an arduino controller. It was either 1-10v signal or a PWM signal (i would have to look again at what I did.). I have been running my pair on this controller for a year approx.

3 wires going to pump - pwr supply +, pwr supply -, signal