Apex Jr. vs Apex Standard

[Wretch]

Originally Posted by Aquattro

You can get overly complicated with profiles and virtual outlets, but that's advanced stuff. All basic functions are drop down menus. Even setting basic pump profiles is easy and graphical, then you can manually code stuff. I usually use the manual "advanced" tab to type in my code, but you don't need to

Did you buy the jebao to apex module for your pumps?

[Aquattro]

Originally Posted by Wretch

Did you buy the jebao to apex module for your pumps?

No, Torx on the board here sells cables. Cheaper than the module, plugs into the variable speed ports (on the full model)

[Wretch]

Originally Posted by Aquattro

No, Torx on the board here sells cables. Cheaper than the module, plugs into the variable speed ports (on the full model)

so you used the same power supply that came with the pumps?

[Wretch]

Do you guys really tell your wives what you spend on this stuff?

[Aquattro]

Originally Posted by Wretch

so you used the same power supply that came with the pumps?

Ya, nothing changes, I just don't use the controllers. And when I need to replace the pumps, I can buy just the stand alone units for even less than the whole kit. You also get finer control using the Apex over stock controller.