alk vs salinity?

[reefwars]

if you want to drop alk in salt mix its quite easy to do before even adding it to your system , again using the salinity values to monitor parameters like cal and alk is going to be impossible to do as every bucket of salt is different then the one before slightly and some drastically

you have to realize that salt alone almost always never keep alk and cal in check for mature tanks unless the tank is tiny and changes are large , in a heavily stocked hard coral tank with lots of coraline youll have to do about %50 per day to keep levels stable....thats not really a good way of doing it unless money is no object lol even then the jumps are not healthy either.


if you don't have corals im not sure why your worried about rtn on acros?


are you going ULNS?

[146clark]

I'm not worried about rtn or stn at this moment as this system has no corals. As for cal and alk ect those will not be supplied by water changes I will dose with an automated system as all my systems are. The only question is the salinity for an sps dominate ok at 1.023-1.024? Has anyone done this with any luck? Or does everyone just run 1.025-1.026 because that's what the salt manufacturers give there parameter quotes at

[Aquattro]

Salt manufacturers recommend crap all over the map. The water on reefs is 1.026 which is why we use that value. I still don't quite grasp why you're insisting in using less? If you have to maintain everything else via dosing, what is the value?

[146clark]

There is no value just curiousity. I appreciate everyone's comments

[Aquattro]

Well, for curiosity's sake, I suppose you probably could keep a reef at 1.023. I'm sure there are enough refractometers out there that are out that much I ran a reef at 1.031 for almost a year, nothing died lol

[146clark]

The reason for using it at lower salinity is because right now with the salt I use I get the dkh level I want. If mixed to 1.026 it's at a value I don't want.

[Aquattro]

Well, as Denny explained, I wouldn't use salinity as a means to control alk. Use a different salt if it's that important. RBS is low, and other than costing more, nothing wrong with it. You don't NEED alk to be low just to run zeo, running it a bit higher is fine.
But, your whole tank will be at whatever level you set the alk. Say 7. If you then do a 20% water change with IO at 8.5, the net result will be pretty darn close to 7 and will balance out quickly with the system.

But, you do seem insistent on running low salt, so given that, I don't think anything terrible will happen. Just not something I would personally do.