Apex network connection

[Aquattro]

You can probably just use SET On in advanced programming then in the control panel, set them to ON.

[Doug]

Originally Posted by Aquattro

You can probably just use SET On in advanced programming then in the control panel, set them to ON.

I tried that before Brad. Just did it again, still switching. So did it all again. Thought I had it this time. Just switched off.

[Aquattro]

What is switching? As in some programmed logic has to trigger the event. Is the outlet marked to ON or Auto?

[Aquattro]

Here is my skimmer outlet

Fallback ON
Set ON

In control panel, set to On.

It's just always on

[Doug]

Ya, my main bar setting are the same Brad. Redo again. Same as that. Still switching. Going to have to go read everything again.

[Aquattro]

I would just email tech support, or at least check in their forum. The whole bar isn't plugged into a switching outlet is it?

[Doug]

Originally Posted by input80

Hi there Doug, just a shot in the dark, is it possible that the plug/outlet is overloaded?

No Im only trying to run a small pump on it and it switches even when empty.

Originally Posted by Aquattro

I would just email tech support, or at least check in their forum. The whole bar isn't plugged into a switching outlet is it?

No its plugged direct into the wall.

[Doug]

I can't speak..Arrrrrrrgggggggggggggggg

Added another Energy Bar 4 and same freakin problem. No control. Three outlets switching. Cant find them on Fusion with the plugged in lamp. Blah, blah and so forth.
Im going back to ReefKeeper soon. This is just stupid that its a head scratcher everytime you need to figure something out.

AND I don't remember how I fixed it last time.

[input80]

Hi there Doug, just a shot in the dark, is it possible that the plug/outlet is overloaded?