![]() |
|
#1
|
|||||
|
|||||
![]() Quote:
![]()
__________________
Doug |
#2
|
|||||
|
|||||
![]() Honey as a supplement? That's really weird. Nice tank by the way.
__________________
240 gallon tank build: http://www.canreef.com/vbulletin/sho...d.php?t=110073 |
#3
|
|||||
|
|||||
![]() Looking good Markus
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. |
#4
|
||||
|
||||
![]() Thanks, sadly its not really looking good. Sitting at about 80% Sps loss right now...just can't figure out what is wrong. Watching all parameters and they are normal. PO4 is a little high at (.06) Checked equipment for failures....replaced some just for the heck of it. Changed GFO and changed carbon brands just in case. Scrubbed my water change station down completely. Changed Di and prefilter on rodi.
Last resort has been doing 100G water changes every day...trying to change something for the positive. Fish are happy but dead corals bring algae and cyano. I can't remove them fast enough. Corals develop large white 'spots' and then return in all directions from each spot with a few days.
__________________
Mark... ![]() 290g Peninsula Display, 425g total volume. Setup Jan 2013. |
#5
|
||||
|
||||
![]() What is your NO3 running at? Also do you dip the sps to see if anything "strange" happens to come off them?
__________________
Casual reefer |
#6
|
||||
|
||||
![]() So my NO3 has been tested by two test kits. API which showed zero and Salifert which showed just above zero. In case I had issues that i wasn't detecting, a few weeks ago I started with Biopellets (though a minor amount). This was well after corals started dying in mass.
I have searched corals for pests but can find none. My frag tank is attached to main tank and frags have gone through same issues. I've dipped them in several dips but nothing visible. Haven't added a coral in many months. I was too full. Might try a Revive dip to see if maybe bacterial infection...not sure if that would help. The only event was an Alk dip that I described above quite a while back. ALK is now 7.1, CA is 500, MG is 1400. Tests done today. Ph is 8.32 and 8.31 on my two probes respectively.
__________________
Mark... ![]() 290g Peninsula Display, 425g total volume. Setup Jan 2013. |
#7
|
||||
|
||||
![]() Just as additional information, this is killing acro, monti, birdsnest...even pocci. Its not particular.
__________________
Mark... ![]() 290g Peninsula Display, 425g total volume. Setup Jan 2013. |
#8
|
||||
|
||||
![]() What lights do you use and what is the schedule
What Alk test kit do you use? Sorry for all the questions. I have had a similar scenario where all my sps died and I'm still confused on the cause, so I'm trying to see if we have similarities.
__________________
Casual reefer |