|
|
|
#11
09-21-2004, 12:08 AM
|
|||||
|
|||||
Lostmind, I appreciate your experience... I'm worried that the scwd would fail sooner with a low-flow pump than it would with a more powerful pump. I am wondering if it would help if every once in a while I put the pump inlet and scwd outlet lines in a jug of vinegar and water and just pumped it in a loop for a while. The pressure might clean the scwd out better than just a bath... probably clean the pump out at the same time.
I wonder why there is such a wide range of experiences with this device. Some people don't clean them and they last over two years. Some clean them regularily and they fail. Some are silent, some grind... Are there different models or generations of scwds or is it just "luck of the draw"? - Chad
__________________
Returning to the hobby after an eight year absence. 
|
|
#13
09-21-2004, 05:34 AM
|
||||
|
||||
|
I have three- one about two years old, one just over a year, the last one just under a year. All work great, no noise. The only cleaning I've done was thinking about I should be doing some. (knock on wood) All three have different flow rates. So I don't know what to say why some work better then others? Yes Wai's does carry them.
On another note I'm upgrading my tank and want way more flow I'm pretty sure I'm going to try the Ocean Motion set up, just deciding on pumps for it. Dave
|
|
#14
09-21-2004, 11:58 PM
|
|||||
|
|||||
|
Dave,
Are you pumping filtered or "dirty" water? Are any of your flows close to 300gph? I figure that at that rate it will take me around 20 seconds to switch back and forth. Let me know if you will be selling any of your scwds when you upgrade... Thanks, - Chad
__________________
Returning to the hobby after an eight year absence.
|
|
#17
09-25-2004, 02:43 PM
|
||||
|
||||
|
I just came back from a las vegas pet show and have see the new prototype of the 1" version serie
they will be out in about a month 
|
|
#18
09-25-2004, 03:17 PM
|
|||||
|
|||||
|
Stephane,
Did you notice if they have also redesigned the 3/4" version? I read somewhere that the new ones would allow you to take them apart for cleaning. Hope so. - Chad
__________________
Returning to the hobby after an eight year absence.
|
|
#19
09-29-2004, 04:12 AM
|
||||
|
||||
|
I didn't look at the 3/4 sorry
but the 1" could be dissasemble for cleaning and also it came with replacmeent part to change the swithching time from one side to another very great impovment IMO
|
Linear Mode
