![]() |
|
#1
|
||||
|
||||
![]() Also you are only getting RO water from the grocery store, not RO/DI water. I would invest in a RO/DI unit, they are cheap.
|
#2
|
||||
|
||||
![]() Hi,
If you also have very little coraline algae, ie, rocks lock a little bit gray, your nitrates are too low. Corals (and coraline algae) do need a very little bit of nitrates to feed on. Just be careful not to overdo it. Levels of 2 parts per million might a minimum to strive for but watch carefully. AquaAddict |
#3
|
||||
|
||||
![]() Thanks for the response everyone. From what I gather the Phosphates need to come down and the nitrate come up slightly. Cool. I can do that. Now the next question, I am running a GFO reactor already with the phosphates at the level they are now. Perhaps the media is not working correctly. Any suggestions on what GFO media to try and use?? I think before I go to crazy that is the first thing to achieve. Once the phosphates come down we can drive the nitrates up slightly. To answer the coraline algea. I have next to none. It has never grown in the tank and the little bit I seeded never really did anything. Thanks for the replies, keep em coming!
|
#4
|
||||
|
||||
![]() Unless your carbon dosing your not nitrogen deficient so don't worry about raising No3
As for gfo any phosphate removing media works , chances are yours is exhausted as it can only hold so much phosphate . The first batch is used in 48hrs if it's high Po4 then each batch afterwards will last longer as long as your inputs don't over weigh the exports High phosphates inhibit growth in hard corals A high alkalinity would actually get you better growth in hard corals coupled with a higher ph , but yours is a tad high leaves no wiggle room. Lastly buy good test kits , your Po4 may not even be accurate if it's not verified ![]()
__________________
........ |
#5
|
||||
|
||||
![]() Api is not good , buy some good test kits then you'll have a better plan . You can't do much on false numbers and Api is hit or miss on what test is worth trusting
![]() I use a mix of elos , salifert and Hanna ![]()
__________________
........ |
#6
|
|||||
|
|||||
![]() How about magnesium? I think IO salt is generally a little low so you likely are as well. Several years back when I started running GFO and boosted Mg to fight hair algae the coraline algae growth really took off in my tank and the general stoney coral growth increased as well.
Aquarium Chemistry: Magnesium In Reef Aquaria By Randy Holmes-Farley, Ph.D. http://www.advancedaquarist.com/2003/10/chemistry
__________________
"We shall dive down through black abysses... and in that lair of the Deep Ones we shall dwell amidst wonder and glory forever." - H.P. Lovecraft Old 120gal Tank Journal New 225gal Tank Journal May 2010 TOTM The 10th Annual Prince George Reef Tank Tour Last edited by whatcaneyedo; 09-24-2014 at 02:10 PM. |
#7
|
|||||
|
|||||
![]() Mag has never been a limiting factor for me using IO. I did start adding it with my new build, but can't say I see any difference.
__________________
Brad |
#8
|
||||
|
||||
![]() Ok, so plan of action is, new test kits. Have to order some or wait till I hit the big city next. I don't think my LFS has anything else other than the API I already have. Have to call and check. I had no idea the GFO was only good for a few days on the initial go round. The bucket says it good for a couple of months before needing changed out. I will re-start that off tonight. Thanks for the replies everyone. Keep the ideas and knowledge coming. I'm learning as I go and every little bit is sure welcome!
|