|
|
|
|
|
#1
08-18-2014, 11:16 PM
|
|||||
|
|||||
Yea I'm using two floats, but I have it set up so one is in the water and one is out. Not sure if thats how most people do it, but my thinking was if the water rises up to the second float then it shuts down the ato.
|
|
#3
08-19-2014, 02:22 AM
|
||||
|
||||
|
|
|
#5
08-19-2014, 03:33 PM
|
|||||
|
|||||
|
This has worked without issue for me so far:
Set ON Min Time 000:30 Then ON If Sw4 OPEN Then OFF If Sw1 OPEN Then OFF If Sw3 CLOSED Then OFF Switch 4 and 1 are just like yours. 3 is a water on the floor sensor. When it comes on it runs for at least 30 seconds... but I should add some language so that it doesn't just run steady if the switches fail.
__________________
"We shall dive down through black abysses... and in that lair of the Deep Ones we shall dwell amidst wonder and glory forever." - H.P. Lovecraft Old 120gal Tank Journal New 225gal Tank Journal May 2010 TOTM The 10th Annual Prince George Reef Tank Tour Last edited by whatcaneyedo; 08-19-2014 at 03:36 PM.
|
Hybrid Mode
