Scott's 135 gallon display tank build

[Gp Scott]

So when I wanted my tank in the wall I wanted it to be flush with the drywall and no trim so the only gap I left was enough to get a trowel thru on the top.

[matt_C]

Set up is looking good!
Looking forward to see it full of water!

[Gp Scott]

Before I finished with mud ,tape , paint I wanted to fill with water so I had to start pluming. I cut a hole in my floor below the tank to run the pluming thru the floor to mech room. I purchased flex PVC to do the job.

[Gp Scott]

I did the pluming on it enough to test the tank and sump with tap water.

So I filled the tank and sump and ran the system. Every thing ran fine but the mag 24 was noisy even for being down stairs so I temporarily rapped it in bubble rap to see if I could make it quieter and it did. Also my herbie was making noise and air locking so Matt at concept told me to make a dorso. It worked but I can still hear water running down the drain but I will deal with that later.