|
|
|
|
|
#2
06-17-2014, 04:55 PM
|
|||||
|
|||||
I did aluminum and then painted it black. It hides the welds nicely but is a bit dramatic. Then again its only seen from the "tank room" side of things....
I found anything with wood gets covered in salt and swells a little from the moisture. Then again, I do have some seriously splashy a$$hats for fish...
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free. 
|
|
#3
06-17-2014, 05:41 PM
|
||||
|
||||
|
Have you thought about acrylic? I saw a couple years ago in cayman islands a light hung with acrylic and when light went through it it was pretty much invisble so it looked like the light was floating. I don't know if you would be able to do it with the way you want to hang your light. Its still a pretty cool idea though.
On a separate note I agree with the guys saying to router it in then add aluminum where you can't see it. Good Luck !! 
|
Hybrid Mode
