|
|
|
|
|
#2
03-10-2014, 12:58 AM
|
|||||
|
|||||
Try to find a fitting called a 'bushing'. Not sure if HD has them, but most plumbing suppliers should (like Noble, {Lougheed at Blue Mtn}).
Mark has one in his picture just before the valve. They take up far less room than a few reducers in line. Don't think they make a 1" to 1/4", but you could go 1" to 1/2" and 1/2" to 1/4" fer sure. 
|
|
#3
03-10-2014, 01:22 AM
|
|||||
|
|||||
|
I tried doing this same thing run my ca reactor with my return I only used the 1/4 jg valve to controll flow. It did not work just no control either to fast or too slow flow I would assume the larger valve would help with that issue. By the way it sure looks like a ball valve not gate. I run mine off a syphon now works good for me more control it still not perfect Peristaltic pump is idea but more money.
|
|
#4
03-10-2014, 06:02 PM
|
|||||
|
|||||
|
Thanks for all the suggestions and tips.
I'll try make it out to a plumbing store soon. Thinking, put in a bushing, gate valve, another bushing down to 1/4" and then a JG type connector...
__________________
- S H A O -
|
|
#5
03-10-2014, 08:25 PM
|
|||||
|
|||||
|
I used bushings and had a JG fitting that screwed into the bushing. Worked fine for years. The JG ball valves are not the best for fine adjustments. I used to run my reactor wide open so it wasn't an issue. Now I don't run a reactor and I sleep better at night... LoL.
Cheers, Tim
__________________
www.oceanfreshaquarium.com/foz-down.html - Foz Down - an easy way to eliminate algae outbreaks caused by Phosphate and bring back the fun of reef keeping.
|
|
#6
03-12-2014, 10:51 PM
|
|||||
|
|||||
|
the only issue is by using a ball valve you don't have a very good adjustability as its oening is not linear, try find a "flow controle valve" which idealy would be a needle valve or in worst case a diaphram or gate valve (last two not really flow control valves but still better than using aball valve)
Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive.
|
|
#7
03-13-2014, 01:04 AM
|
|||||
|
|||||
|
Ok so I used a bushing to drop to 1/2"
Then threaded in a 1/2 to 1/4" quick connect Now all I need is the valve... I have a JG ball valve, but from all the input here, looks like what I need is a needle valve. Now I've sourced out some, but all from the US. And these things aren't cheap! $20-25USD +shipping... Any ideas for a local source? I'll call Sheret tomorrow.
__________________
- S H A O -
|
Hybrid Mode
