Help ith wireless plm-pic card

[BlueTang<3]

Looks like u open light composer load your project and hit the transfer button and then hit the load button after I was just changing my light settings and this worked.

[Scythanith]

Dumb question…. where is the transfer button?

[BlueTang<3]

Ill take a screen shot tonight,

Do you have the new version of profulix control

[Scythanith]

I am using 6.0.4. The newest one out. They said 6.0.5 may be released soon.

[Scythanith]

Here is what I have tried:

Open ProfilucControl 6.0.4
Connect RS232
Click illumination on the right menu and open drop down menu
Click light composer
It asks me to load own project, which I do. Click OK.
Now I see all the light sources of the Mitras, and my illumination runs. I can click on new under the illumination runs. Other than that the only thing I can select on the front page is test illumination run. If I check it and try to run it nothing happens on my Mitras. It says illumination channels must have been transmitted before, but I don't know how to do that.

I have used this light project through GHL Control Center before I installed the PWC card, so I know it works.

I seem stuck at the transmit to Mitras part. The PWC card has a solid green light and a blinking red light if that matters.

[BlueTang<3]

Originally Posted by Scythanith

Here is what I have tried:

Open ProfilucControl 6.0.4
Connect RS232
Click illumination on the right menu and open drop down menu
Click light composer
It asks me to load own project, which I do. Click OK.
Now I see all the light sources of the Mitras, and my illumination runs. I can click on new under the illumination runs. Other than that the only thing I can select on the front page is test illumination run. If I check it and try to run it nothing happens on my Mitras. It says illumination channels must have been transmitted before, but I don't know how to do that.

I have used this light project through GHL Control Center before I installed the PWC card, so I know it works.

I seem stuck at the transmit to Mitras part. The PWC card has a solid green light and a blinking red light if that matters.

Yeah the light means its geting interference, I don't remember if you stated are all your lights set as slaves ?

[Scythanith]

Yep I had the 3 mitras set to slave and the PWC card set to master. Same channel and separate addresses.

I temporarily removed the wireless card and set one of the mitras back to master. They work perfectly again. But my problem isn't solved.