Help ith wireless plm-pic card

Scythanith · #1 01-09-2014, 01:32 AM

Quote:

Originally Posted by BlueTang<3

Well I am officially special...
Two problems here

If green and red light flashing you have an issue, green is receiving a signal from somewhere, turns out you need all the lamps on to be slave. Once the lamps are slaves you need to make sure u set the clock in your new controller to the actual time

Problem solved now we have light control

BlueTang, how'd you get the Mitras to run your light composer project? I loaded my project into 6.0.4 and it I can see the illumination run under the illumination tab…. but nothing is happening. The lights are dark. I can make them flash with the thunderstorm feature, but for some reason they aren't carrying out my light project. Did you click on the copy illumination run box and select a channel under the illumination 1, 2, 3 headers?

Cheers!
Scott

BlueTang<3 · #2 01-09-2014, 01:54 AM

I will look here quickly it seemed easy but I will hook up my computer and see how I did it.

I take it you have all your lights set as slaves already

BlueTang<3 · #3 01-09-2014, 03:01 AM

Looks like u open light composer load your project and hit the transfer button and then hit the load button after I was just changing my light settings and this worked.

Scythanith · #4 01-09-2014, 04:32 AM

Dumb question…. where is the transfer button?

BlueTang<3 · #5 01-09-2014, 12:19 PM

Ill take a screen shot tonight,

Do you have the new version of profulix control

Scythanith · #6 01-09-2014, 02:46 PM

I am using 6.0.4. The newest one out. They said 6.0.5 may be released soon.

Scythanith · #7 01-09-2014, 02:54 PM

Here is what I have tried:

Open ProfilucControl 6.0.4
Connect RS232
Click illumination on the right menu and open drop down menu
Click light composer
It asks me to load own project, which I do. Click OK.
Now I see all the light sources of the Mitras, and my illumination runs. I can click on new under the illumination runs. Other than that the only thing I can select on the front page is test illumination run. If I check it and try to run it nothing happens on my Mitras. It says illumination channels must have been transmitted before, but I don't know how to do that.

I have used this light project through GHL Control Center before I installed the PWC card, so I know it works.

I seem stuck at the transmit to Mitras part. The PWC card has a solid green light and a blinking red light if that matters.