Vertex omega 130

Chase31 · #1 12-24-2013, 03:14 AM

So finally got a chance to get home and change my carbon and 10 mins later it was low in the chamber. As I suspected the bubbles were 2-3 inches above the bubble plate. As before they were below. Well I started adjusting it and came back after 20 mins and it was below the plate and overflowing. So should I change my carbon again? I have a dual brs reactor and filled them both up about half way, carbons only been in for an hour or so at this point. Also like to add that I dosed my prodibio today before the carbon

Ryanerickson · #2 12-24-2013, 03:21 AM

One of the bikes in prodibio make skimmers go crazy don't remember what one

Ryanerickson · #3 12-24-2013, 03:22 AM

Sorry viles

BlueTang<3 · #4 12-24-2013, 04:08 AM

Quote:

Originally Posted by Chase31

So finally got a chance to get home and change my carbon and 10 mins later it was low in the chamber. As I suspected the bubbles were 2-3 inches above the bubble plate. As before they were below. Well I started adjusting it and came back after 20 mins and it was below the plate and overflowing. So should I change my carbon again? I have a dual brs reactor and filled them both up about half way, carbons only been in for an hour or so at this point. Also like to add that I dosed my prodibio today before the carbon

The skimmer would have lost the head because of you in the tank, oils from you skin will cause the skimmer to drop down.

BlueTang<3 · #5 12-24-2013, 04:12 AM

Have you tried to pull the hose off the bottom of the silencer, its not uncommon for shipping stryfoam to partially block the air intake causing to bubble over. Are you using ro water? I was told with my first bubble king that I needed ro water as so as I switched it stoped bubbling over.