![]() |
|
#1
|
||||
|
||||
![]() Dunno why but it seems like putting the intake into the pump makes it stop running. So pretty much I would hav to take the intake out so its bare propellar spinning slowly then keep plugging and unplugging till it spins fast if Im lucky after 20mins then I can put the intake back into its housing and 9/10 the pump will stop again.. All this while trying it under my tiny sump with barely any room to move lol. Once it runs good with the intake in I never shut off my skimmer but had to to rewire. So u can imagine I was goin nuts each time it turns off.
|
#2
|
||||
|
||||
![]() Any1 know if an aquabee 2000L/hr will fit my skimmer?
|
#3
|
||||
|
||||
![]() Sounds like what has already been said.
You should try running it in a vinegar bath in a separate pail. I'll bet the pump has been running in that cramped sump for a long time. It will be a pain to get out |
#4
|
|||||
|
|||||
![]() Quote:
__________________
Always looking for the next best coral... 90g starphire cube/400mhRadium20k/2 XHO/2x27w UV/2x39w T5/ 3 Trulumen led strips |