Grizz's 8' - 300 gal + 60 gal + 30 gal OMG Build!!

[lockrookie]

Originally Posted by The Grizz

This is the actual locks I want to use but dont know if I need to have a power supply for each lock or if I can just use one power supply.

Any advise Jeff?

You need a constant power to the electric mag locks and something to interrupt that power to open them as for the latch style you add power to release

[The Grizz]

Stopped at Lee Valley today & picked up a box load of these latches, very cool, sleek & easy to install. I will snap a few better pics of one installed tomorrow.

[roblarss]

Awesome. Saw these about a year ago and have been waiting to try them out myself.

[The Grizz]

Ok so as promised here are some pics of the latches installed. Thanks for the tip Rob much easier locking solution.

Doors closed and locks engaged:



Magnetic knob on the outside holding the lock tab in so the door can open:



Now a neat feature, as you see in the first pic the red lever is down. If you hold the lock tab in and flip the red lever up it will hold the lock tab in so you can open & close the door with out the magnetic knob:

[The Grizz]

UPDATE:

Got my light rig up & running........click on the pic & it should work.




Pic of the heat sinks I built as well as the driver bank.

[The Grizz]

Profilux 3ex all set up:



Profilux Touch mounted & running:



Profilux power bars & touch interface mounted & running:

[The Grizz]

Still need to find the right spot for my Profilux 4 pump doser & get a VorTech Control module as well as a PLM-PWC expansion card to wireless control the GHL Mitra that I am going to put over the 60 gal cube.

[Baldy]

Originally Posted by The Grizz

this one got the attention of the tech geek/electrician/led freak/diyer in me. I used inventronics drivers on my led build as well and i love them. do you have your driver setup documented anywhere?

[The Grizz]

Originally Posted by Baldy

this one got the attention of the tech geek/electrician/led freak/diyer in me. I used inventronics drivers on my led build as well and i love them. do you have your driver setup documented anywhere?

Not really but I should have put it in my LED build thread. Simply put from left to right, black divers are for reds & greens, small silver drivers are for the high noon white's, first 2 large silver drivers are for the blues & last 2 large silver drivers are for the cool whites. Each row of LED's are controlled by the EVG boards, 2 rows of LED's per board all controlled by my Profilux 3ex controller.