Mp40wES Bearing Replacement

[Madreefer]

Originally Posted by gregzz4

I replaced the bearings in 2 MP10 dry sides last year
For me, total waste of time and money, even with the best (brand/style) ones recommended in the MP40 threads, and the supplier's lube
Plus, one of the bearings I received was pooched right out of the shoot
No improvement in sound, and a new dry side was my fix
In the linked thread you'll find the bearing #s for your MP40 and where to buy them, along with some tools if you like

To remove the bearings I hung them in a small vice and tapped the shaft out with a punch
For pressing the bearings, I used the vice and a socket that matched the inner race
Tapping them out is tricky due to the magnet

If you do decide to go this route, make certain you 'press' the bearings
I know you asked about it so you must be aware, but, I'll state it anyway
Hammering/jolting the new bearings on will more than likely destroy them

Plus, you must be careful not to damage the magnet

Lots of info in the link and there's a step-by-step how-to on the first page
Good luck

I'm with Greg on this one. I did all of the above with same results. Not worth the bother.

[asylumdown]

noisy little buggers aren't they? Mine are literally inside of a wall and I can still hear them when they ramp up above 80%

[msjboy]

nanotopia from her link might help ( MP10 though):
http://www.nano-reef.com/topic/31381...-by-nanotopia/

( she is in fraser valley ) She also says maybe go to a skateboard shop where they have the proper tools to band the bearings out )

[HaZRaTTy]

I think i'm going to stray away from the bearing replacement as I have read way to much on how it doens't help much / the effort it takes.

Yes greg I know a few things about bearings and a hammer and bearing does not go well haha.

Thanks for the the replies!