![]() |
|
#1
|
||||
|
||||
![]() i dont have mitras, and more a diy set up, however want to add green and red led
So now i can putlets say 10 red and 10 green and have them blasting 50% or 5 red and 5 green at 100% So if you would have them at 50% and you have ..... Number per unit, it gives me some insight in how many i would use at 100% Reason for this is becouse i have all my dimming drivers in use, and have a few CC drivers left |
#2
|
|||||
|
|||||
![]() Hi
You can set the mitras LED channels to anything you wish if you only wish to run reds and greens then this is fine just set the rest of the channels to 0% you can then adjust the red and green channels to any % intensity you wish. |
#3
|
||||
|
||||
![]() Quote:
Question is, what douse men have the red and green at, I know this is preference, however if the average has them at 20%and there would be 7 above a tank, than in my case it would be the same as 1 at 100% (+- whatever my preference is. Same is if in general thy have them at 50% than i would have some indication that maybe I should use 3 at 100% for each 6 at 50% on he mitras. Sorry, the factory build units are out of my budget, and i already have a 200+ led rig, that I want to adjust a bit in to a full spectrum Unit |
#4
|
|||||
|
|||||
![]() does anyome have some other specrturms that I can try say like the 8-10-12K range.. that is already done with a nice night time illumation
i thought that if I go that route i could raise my light a bit. for more of the spread.
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. |
#5
|
|||||
|
|||||
![]() Looks lime Elf on the shelf has gone fishing of the Mitras this Xmas!
![]() |
#6
|
|||||
|
|||||
![]() But wait, looks like Elfie is into a whopper!
![]() check back to see what Elfie has caught everyone ![]() |
#7
|
|||||
|
|||||
![]() Look what Elfie caught!!! a nice pair of Mitras Sunglasses! Well done Elfie nice catch!
![]() |