stand

[dawen]

Originally Posted by byee

+1 for kacairns opinion.

Your stand is well built!

Is the supporting weight only on the corners of the stand? I checked the corners are all level, but only the middle of the supporting frame from front to back is out by 1/16" coz of the warped 2x4" do you guys think it's ok for resting tank?

Sent from my C6906 using Tapatalk

[byee]

Will it be easy to replace the horizontals cross members for something without the dip?

If not, you can always shim the plywood top to be straight. Go to your local HD and pick up some laminate counter top samples and use them as shims.

Good luck!

[hillegom]

I don't think 1/16 is anything to worry about. You are going to put down some of that pink styrofoam under your tank right? That should even things out.
And if it is a problem after you try with fresh water, then when you drain it out u can use that shim as mentioned.