|
|
|
|
|
#1
10-20-2013, 05:05 AM
|
|||||
|
|||||
Coralgurl I actually had my nuetral burn out at the mast
One of the connections on the hot was bad and melted the neutral Kinda scary actually because it actually lit my cable line on fire due to the surge through the ground of the cable line Had I not been there or been asleep my whole house would have been in flames
__________________
Way too much time and money has gone into this hobby....and yet, I CAN'T STOP 
|
|
#2
10-20-2013, 05:15 AM
|
|||||
|
|||||
|
when you remove the panel to access the board there is a switch that shuts off power to the furnace, if you push the switch in it should power the board, the most common problems with that type of furnace is the vent motor which should be running, the pressure switch that tells the board the vent motor is running, the hot surface igniter, or the condensate drain is plugged.
The vent motors can seize up over the summer when not in use.
__________________
Crap happens, that's why they sell toilet paper in 48 roll packs!
|
Hybrid Mode
