![]() |
|
#1
|
|||||
|
|||||
![]() There's no die off (at least not yet), just loss of colour saturation.
I'll try adjusting the programming and lowering the intensity. Sounds like it could be too bright / too close (at least I'm not running at the higher intensity settings!).
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee! |
#2
|
|||||
|
|||||
![]() Quote:
__________________
ATI 48" 3x75W LED with 8x54W T5, 2xTunze 6105, 2 x Maxspect Gyre XF150, Bubble King Mini 200 ( soon to be replaced by a Bubble King SM 200), Eheim 1262, Via Aqua 300 watt Titanium heater, JBJ ATO, Apex Controller |
#3
|
|||||
|
|||||
![]() I've done two things recently even tho you're only supposed to make one change at a time.
- raised the lights a bit each day so the wife doesn't notice. initially she said the light bleed to her spot on the couch was a problem but i did this a while ago without her noticing. now i'm probably 8 or 9 inches off the water and plan to eventually hit 12" or so. - dropped both my cool white and neutral white by a lot. trying a more blue spectrum to see how things react. i reduced their output a lot while also turning the overall power from 60% to 100%. my tank looks a bit brighter but the corals are probably getting the same or a little less light than before (higher up, less white more blue). so far so good. my tank was crazy pale and i had a few sps start to go which has never happened to me before. as i mentioned last night tho tony i've also started feeding heavier too. |
#4
|
|||||
|
|||||
![]() Quote:
|
#5
|
|||||
|
|||||
![]() |
#6
|
|||||
|
|||||
![]() Here are some Mitras LED photos to enjoy
Mine first ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
#7
|
|||||
|
|||||
![]() Large photo sorry
![]() ![]() |