|
|
|
|
|
#1
08-29-2013, 04:26 AM
|
||||
|
||||
I need to readd my Tunzes. I've got 2 smaller ones and 2 bigger both on a variable controller. I find it difficult getting flow right, and go a little OCD about possible stagnant zones, then peel the paint off my corals from having my pumps too high.
Right now my pumps are sitting in a bath getting cleaned up. I also have to figure out how to negate the powers of magnetism so I can reclaim two mounting brackets that fused to each other I was also scared crapless dealing with my Urchin. I actually ended up pulling all the water out of the old tank he was in, and removing most of the rock work so I could get at him. Plus dropping him 4 times (while in the tank) helped knock enough spines off so he'd fit in my net. 
|
|
#2
08-29-2013, 04:39 AM
|
|||||
|
|||||
|
Separating the magnets is easy enough
Just wedge something between them (such as a flat screwdriver), then stick your finger in between and yank 'em apart (but don't lose your grip  )I store all my extra magnet parts with a thick piece of cardboard between them
|
Hybrid Mode
