|
|
|
|
|
#1
07-13-2013, 02:05 AM
|
|||||
|
|||||
Haha, that's quite the load. Out of curiosity ( and you can ignore the ?)but how many pumps did you end up ordering?
|
|
#3
07-15-2013, 08:52 PM
|
|||||
|
|||||
|
Quote:
Anyway I can still get in on this, since you have some left overs?
__________________
- S H A O - |
|
#4
07-15-2013, 10:18 PM
|
||||
|
||||
|
There are some left for sale. But I need to try to make a couple bucks on the remaining units so they will have to be sold at regular price. You can use the CANREEF promo code and get a few $ off.
__________________
Nick |
|
#5
07-16-2013, 05:52 AM
|
||||
|
||||
|
Can I get some measurements from the WP-40 output? I'm having an external wavebox built (with a tank) and the wavebox is designed around one of the new WP-40's being inside, with the hole drilled in the tank back wall somewhat critical to make large enough (though without being tooooo large
 )I've read 55mm outside diameter, but if I can get someone to confirm that would be great! Also the long-wise dimensions (with and without the mount). A few pictures of it sitting next to a tape measure would probably be reasonable enough  Nick - do you think you'll have mine ready when I'm in Kelowna there (July 29 -> Aug 5ish)? (you are in Kelowna, right? )Thanks! Craig
__________________
Single System Setup: 210G SPS reef, 225G FOWLR, 72G water change, 50G frag, 120G sump. I promise a journal at some point! (anyone need some coral frags? I likely always have stuff that is frag-ready) |
|
#7
07-17-2013, 08:46 PM
|
||||
|
||||
|
Quote:
When i am back in the office i can measure one up for ya and even measure the opening that is on the Marinetech wavebox to give an idea of what size hole might work well(in a few hours). I can't think of them not being her by mid week next week. So even if things go horribly wrong they will be here in time for you when you are in Kelowna.
__________________
Nick |
Hybrid Mode
