Daplatapus's upgrade

[daplatapus]

Ok, so I'm re-visiting the idea of eurobracing this tank. I cleaned off the piece I removed and it's totally polished.





So I'm thinking this tank is a good candidate for glass euro bracing. I've looked a fair bit on line and I can't find any kind of calculator for figuring out how wide the bracing should be. My gut's telling me 3" or so.
Then while I'm searching for this, I run into the different ways to do euro bracing. Run the front and back strips inside the tank and the 2 sides and 2 centre braces on top. Or run the front and back on top of the tank, the 2 ends in-between the front and back and the centre braces on top of the front and back braces.
Argh, why can't anything be simple, lol.
So, for those of you who have 210's or similar 72" X24" tanks, what size is your bracing and where do they sit on your tanks? Pics are welcome too.

[denny_CC]

pm'd with a much better price then that lol :P

[daplatapus]

Lol, ya. When I saw the quote I nearly fell over. First of all they would only sell me tempered. Not sure if that was accurate or not. So I got them to quote both tempered and float. I didn't know exactly what sizes I needed but for rough pricing I got them to quote the following sizes:
All pieces were 12mm glass
2 - 72" X 3"
4 - 24" X 3"
1 - 22 1/2" X 16"
2 - 16" X 8"
1 - 22 1/2" X 8 1/2"
2 - 12" X 4" (for patching the internal overflows)
For untempered that was $781.44 before tax
Tempered was $921.35 before tax.

All pieces had polished edges.

[daplatapus]

Hey Lockrookie, was there somewhere you got your euro brace measurements from? I'd just like a bit of confirmation on sizing and placement of the glass pieces before I order anything.
Or if anyone else has a 210 can speak to this too that'd be awesome!