![]() |
|
#1
|
|||||
|
|||||
![]() Here is a shot I took last night.
![]() ![]() Thanks for looking! ![]() Last edited by neoh; 05-16-2013 at 09:49 PM. |
#2
|
|||||
|
|||||
![]() Nice assortment of goodies, i love wrasses too
![]() |
#3
|
|||||
|
|||||
![]() Update: 5/18/13
Moved some things around, and found that a 2" frag of yuma ricordia was attached to the underside of a piece of rock - along with an entire colony of green basic zoanthids! Fancy that. However; when I turn the rock around I cover up a 4" ricordia that is attached to the other side of the rock. I gave him a little tug to see if he would dislodge, but he's on there good - and I really don't want to cut him off, so he will forever be facing the backside of the tank. No justice with this picture, of course: ![]() Added a very nice duncan to the mix, which I'll take a picture of of once he opens up. Spent a few hours hooking up the RODI system to the bottom of the sink. Not as difficult as I had figured it would be, just one stop to Home Depot! Currently filling up the buckets for a water change and backup water. ![]() |
#4
|
|||||
|
|||||
![]() Quote:
Most of all congrats on your new success with the salties. |
#5
|
|||||
|
|||||
![]() Thank you very much!
![]() Here's where it connects to the sink. I bought the part at Home Depot for $6 I believe. I glued the hose into it to make sure it doesn't pop out. It's actually making me pretty nervous about popping off. Then it goes to this: ![]() And yes, the waste water goes down the drain. |
#6
|
|||||
|
|||||
![]() Just a weekly update!
Added a few lovely frags from Fragbox.ca, looking forward to watching them grow out. Also went shopping at J&L again. Walked out with another Phosban reactor for carbon, and a speedwave DC pump to replace my rio+ as I've heard good things about them, and after reviews I've had second thoughts about it, but unfortunately haven't figured out a good way to add it to my existing system. Things are getting pretty crowded in the sump, I'll try to figure out a better plumbing scheme to keep things out of the sump. ![]() I'm also looking to plum the reactors together something like this: ![]() I picked up the wrong fittings from Home Depot today, so I'll have to make another trip out there tomorrow. I also added a Jebao WP40 wavemaker to the mix. I'm still not sure if I like it or not. I had to put some floss in the overflow to keep it from making the slapping sound of water sloshing all day. Here's the "command center." ![]() Ca: 440 Mg: 1400 PH: 8.0 Temp: 27.5 Phosphates: 0 Nitrate: 0 ![]() |
#7
|
|||||
|
|||||
![]() Don't worry, that's a compression fitting. Very reliable... if you installed it correctly! JK... you'll be fine!
|
#8
|
|||||
|
|||||
![]() looks good ryan!
|