New Jarduino build gets started

[daplatapus]

Hey Chris,
I'm finally looking at setting up my PWM fans on my heatsinks and I have a couple questions about that schematic you posted up earlier. In there you have 1K resistors, a 10K resistor, 1N4148 diodes, a BC547 transistor and 2N3904 transistors. How flexible are those? The reason I ask is I don't have most of them, lol. I have what Jamie posted in the instructions. 1N4001 diodes, BC549C transistors and 1K and 10K resistors.

[ScubaSteve]

Man, that circuit confused the **** out of me for a few minutes there until I realized what they were doing. Funny enough it's the same way those LDD drivers dim You think I'd know this one by now...

You should be fine Dom. The BC549c and BC547 are basically direct substitutes. The difference between your diodes and his are his are fast recovery diodes, while yours are general purpose. I'd have to go back and look again I think the diodes are just being used as protection in case there is any inductance from the fans. I think the general purpose should be fine because you aren't doing any high-frequency switching.

[daplatapus]

Originally Posted by ScubaSteve

You should be fine Dom. The BC549c and BC547 are basically direct substitutes. The difference between your diodes and his are his are fast recovery diodes, while yours are general purpose. I'd have to go back and look again I think the diodes are just being used as protection in case there is any inductance from the fans. I think the general purpose should be fine because you aren't doing any high-frequency switching.

Thanks man, I've blown a couple things up already, thankfully they were cheap, but waiting the 6-8 weeks for new stuff from China sucks. I didn't want to fry anything else.