|
|
|
|
|
#1
04-20-2013, 06:58 PM
|
|||||
|
|||||
Hooked up
Hooked up and mounted to under side of tank. I chose to run the two adapters externally because of the heat generated by them.
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes. 
|
|
#2
04-20-2013, 07:05 PM
|
|||||
|
|||||
|
Profilux programming
Here is a few screen shots, if your familiar with the profilux, this was actually the easiest set up.
Set up 1-5 volt signal in 1-10v interface  In current pumps, assign pump numbers and program.  
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes.
|
|
#3
04-20-2013, 07:11 PM
|
|||||
|
|||||
|
Waveline pumps
Now that everyone is caught up, let's get started on the waveline.
With the controller open we can again identify the wires.   Again, two wires coming in off the AC/DC adapter, a positive and a negative. Labeled as M+ and M- on the board. Also three wires going to the pump, Labeled 24+, 24-, and VA.
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes.
|
|
#4
04-20-2013, 07:15 PM
|
|||||
|
|||||
|
Three pin arrangement
We need to identify what the pin arrangement is in the plug to the pump.
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes.
|
|
#5
04-20-2013, 08:53 PM
|
|||||
|
|||||
|
Very interesting Bob, I have a question though...did you cut the wires away from the original controler or are they still attach?
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build
|
|
#6
04-20-2013, 09:24 PM
|
|||||
|
|||||
|
Quote:
I had ordered parts for the waveline harnesses about 10 days ago, so I expect things to arrive this week. I actually was thinking of starting this next week, but after talking with Steve looks like we're starting it sooner. I will have a separate harness, so on this project, no the controller will just be set aside.
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes. Last edited by The Codfather; 04-20-2013 at 09:27 PM.
|
|
#7
04-21-2013, 02:16 AM
|
|||||
|
|||||
|
Great work Bob, this looks awesome. I guess a guy really just needs the profilux EVG card? If I didn't want to salvage the original controller I could use the mating connector from that to prevent the need to cut the pump wire.
Any idea what the signal voltage is? The WP40 was 0-5V, is it the same for waveline? What about soft start, can we program this with profilux, I've never tried that myself.
|
Hybrid Mode
